Can some one help me with replacing a fuel press s ensor on a 2005 cts Cadillac
no. go get a jdm engine
You can not replace just the tire pressure sensor on a Boxster. You will need to replace the whole sensor. The sensor is located inside the tire assembly.
loo
There are several temperature sensors on the S-10. Are you talking about the Intake Air Temp (IAT)or MAT (Manifold Air Temp) sensor? are you talking about the Coolant Temp Sensor (CTS)? Are you talking about the Exhaust Gas Temp (EGT) sensor? The IAT/MAT is on the intake manifold before the throttle body. The CTS is on the front of the engine in the thermostat housing. The EGT (if equipped) is on the exhaust manifold close to the head. (So's the O2 sensor)
A cam sensor and crank sensor was not used on that year. If the engine is not firing then I would replace the ignition module that's in the distributor.
problem with the coolant sensor check the connection on the sensor reset your OBD I code if that don't work replace the coolant sensor
Replace it with a new one.
replace your speed sensor
they are located under intake manifold The #1 sensor is located in the front of the engine and the #2 sensor is located in the back of the engine. Remember to replace the intake gaskets once you replace the sensor/s. The total time it took me to pull the intake and locate the bad sensor was about 6 hours. Hope this helps
The Exhaust Manifold Oxygen Sensor needs to be replaced.
The 2010 Cadillac CTS is 6 ft. 0.5 in. (72.5 in.)1 subwoofer(s) wide.