0
From the inside trunk you will see plastic cargo net retainers, turn to the left to loosen and pull upward slightly, then you remove the plastic that covers the trunk latch by lifting straight up. Now you remove a couple more located in the carpet which are the same as the plastic cover ones, move the carpet out of the way and you will find 2 nuts on studs facing forward behind the carpet remove these nuts and be carefull not to drop them, they are difficult to retrive but a magnet on a stick will work if you happen too. The light assembly will pull reward from the outside at this point, push and turn the plastic lamp holder and replace the 3157 bulb! GOOD LUCK!
It will help if you remove the cover for the spare tire and also remove the cargo net retainer that is on the upper side of the side on which you are replacing the bulb that is about one foot forward of the rear. That will help pull away the cardboard type carpet from the side. You will need a 10 MM wrench to unscrew the nuts on the stud that hold the light assembly in place. The brake light bulb is the one at the top of the rack of three bulbs.
What else can I help you with?
How do you replace the rear brake light bulb on a 2004 Honda Civic?
How do you replace the rear brake light bulb on a 2001 Honda civic?"
Where is the fuse for brake lights located for 2004 jeep liberty?
w to replace center brake light in 2004 jeep liberty
How do you replace rear window brake light bulb on 2004 Hyundai Santa f e?
How do you replace rear window brake light bulb in the 2004 Hyundai Santa Fe?Read more: How_do_you_replace_rear_window_brake_light_bulb_on_2004_Hyundai_Santa_f_e
2004 F250 Brake lights not working but everything else does?
replace brake light switch located on brake pedal under dash
How do you shut off ABS light on 2004 Nissan Frontier?
I just had this problem on my 98 Frontier because the brake lights were staying on. I had to replace the brake light switch and the brake light button for it to go out.
How do you replace third brake light 2004 Mitsubishi endeavor?
To replace the third brake light on a 2004 Mitsubishi Endeavor, first, open the rear hatch and locate the cover for the brake light assembly. Remove the screws securing the cover, then gently pull it away to access the bulb. Twist the old bulb counterclockwise to remove it, replace it with a new bulb, and reassemble the cover by securing it with screws. Finally, test the new brake light to ensure it’s functioning properly.
How do you change a brake light on a 2004 LS?
WHICH brake light?
How do you replace brake light on 2004 Kia Sedona?
Remove the tail light assembly cover in the cargo compartment. Take hold of the brake light connector. Push the connector in and turn at the same time. Do the same with the brake lightbulb. Reverse the process to install the new brake lightbulb.
How do you replace a 3rd brake light bulb on a 2004 Toyota 4Runner?
its an LED light, the whole unit has to be replaced. The spoiler needs to come off.
How do you replace brake light on 2004 buick rendezvous?
To replace the brake light on a 2004 Buick Rendezvous, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the tail light, then gently pull it out. Disconnect the electrical connector, twist the bulb socket counterclockwise to remove it, and replace the old bulb with a new one. Reassemble the tail light by reversing the steps, ensuring everything is securely fastened.
How do you replace brake light bulb on a 2004 jaguar s-type?
To replace the brake light bulb on a 2004 Jaguar S-Type, first, open the trunk and locate the tail light assembly. Remove the access panel or cover, then twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, ensuring it's securely in place, then reassemble the tail light and close the trunk. Always check the new bulb by pressing the brake pedal to confirm it's functioning properly.
What is the correct way to replace the third brake light in a 2004 Saturn L300?
Easy! Just goto the 3rd brake light and carefully pull off the cover... CAREFULL not to brake the snaps... before hand though, you have to go to the dealer to get the LED's, see how many you will need.
