how to remove rear axle from 1988 f250 ford
On the rear axle?
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
Top of the rear axleTop of the rear axle
chain it to a concrete wall and drive as fast as you can in the opposite direction
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
The fill plug is on the rear cover of the differential. Remove the rear cover to drain the fluid.
front or rear rotor? jack up wheel that needs rotor removed. remove wheel remove brake pads and caliper for back axle, remove axle nut. u will need special socket to remove this nut slide rotor off axle, making sure u dont drop bearings on the ground to remove front rotor on4x4, it is pretty much the same as rear , except you will have to remove locking hub from axle before you can remove axle nut.
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com
Front axle is a 9.25 American Axle Rear axle is a 10.5 American Axle
2004 SRX is 36mm...
To change the rear axle fluid you can remove the rear cover from the axle and drain it that way. If you don't want to remove the rear cover you can use a pump and a hose to drain it through the fill hole.