Yes but do not take them all off. Leave at least two on the wheel opposite each other before jacking it up. You can loosen those two but do not remove.
First you have to remember to loosen lug nuts before jacking up the car. You also have to remember to put the jack on a flat surface underneath the car (You don't have to lift the car high off the ground). Then you have to finish taking the lug nuts off the car, and remove the wheel all the way. Once you take it off you have to replace it with the spare tire, and screw the lug nuts back on.
No. They may slightly loosened prior to jacking up the car in order to "break them loose". but no more than a quarter to half a turn.
With the car on level ground, in gear and parking brake applied, loosen the wheel nuts a half turn. Get the jack out, make sure to find the right spot for the jack to engage the car. Make sure that the ground is firm and flat where the jack will stand. If you have them, put chock blocks ahead and behind the wheel diagonally from the one you're going to remove. Jack the car up until the wheel clears the ground. Undo the wheel nuts the rest of the way. Pull the wheel off. Put new wheel on. Tighten the wheel nuts enought to seat the rim on the hub properly. Lower the car back on to the ground. Do the wheel nuts up real tight in a cross-wise pattern. Done!
To change a tire on a Jaguar XK8, first ensure the car is on a flat surface and set the parking brake. Loosen the lug nuts slightly, then use the jack to lift the vehicle until the tire is off the ground. Remove the lug nuts completely and take off the flat tire, replacing it with the spare tire. Finally, hand-tighten the lug nuts, lower the car, and then fully tighten the lug nuts in a crisscross pattern.
With car on ground and all wheel nuts tight. Loosen all wheel nuts 3 complete turns. Drive car forward and back about 10 feet. Jack up and remove wheel nuts and wheel.
Improper installation. Lug nuts were loose.
When a car horn goes off while the car is switched off, it means the horn has a bad ground.
To remove the rear wheel on a Honda Jazz, first, ensure the vehicle is on a flat surface and the handbrake is engaged. Loosen the wheel lug nuts slightly, then use a jack to lift the rear of the car until the wheel is off the ground. Remove the lug nuts completely and take off the wheel. Finally, ensure to store the lug nuts securely for reinstallation.
If the car turns off while driving, it can be a sign of a bad ground. It can also mean a fuel system problem.
Possible a bad or corroded ground cable .
The earth (Ground) on any car battery is negative while the live is positive.
take the lug nuts off while you have the car jacked up loosen the nut with a tie in it. FIRST TAKE THE TIE OUT then the rotors should come off. To put back do the same process backwards. ITS REALLY EASY