0
Why the racing motor cyclist bends inwards while taking a sharp turn?
Wiki User
∙ 10y ago
It lowers the air resistance, which lets them go faster.
Wiki User
∙ 15y ago
Wiki User
∙ 15y agoTo reduce the air drag and to rest their necks. It also makes it easier to get some helpful muscle tone in the torso while riding.
Wiki User
∙ 10y agoTo counter centrifugal force, and enable the cyclist to take the turn faster.
Wiki User
∙ 6y agoCyclists bend forward to reduce air resistance.
Anonymous
Reduce air drag
Add your answer:
Earn +20 pts
Why a cyclist bends slightly inwards when taking a turn?
Why does bdsjf of cyclist takes place while taking a turn
What is it called when a mirror bends inwards or outwards?
Convex when it bends outwards, concave when it bends inwards
Why racing bike bend inward while taking a turn?
why racing bike bends inward while talking a turn? answer
In motor racing a short section of narrow bends on a circuit?
chicane
What sport confronts participants with hairpins?
Motor racing. As in hairpin bends
Why a cyclist bends himself towards the inner side of a curved path while turn with high speed?
because ugly
Is a concave or covect the type of mirror that resembles the inner sufrace of a spoon?
A concave surface is hollow and bends inwards.... think of it as conCAVE.... caves are hollow.A convex surface is like a bump and bends outwards... a convEX bump is on the EXterior of an object
Why a cyclist bend himself to take a turn around a corner?
A cyclist bends so as to increase frictional force which produces enough centripetal force to enable him/her to remain a circular path(since a corner is a part of a circular path). Note:Frictional force produces centripetal force in this case
3 examples of maths in an electrician's job?
simple arithmatic such as adding or subtracting fractions from taking measurements. Algebra when doing certain electrical load calculations Right Angle Trigonometry when bending conduit to calculate angle of the bends, degrees of bends, length of hypotenuse which is the two bend points for offsets and saddles. conduit bending CAN be very complex depending on the application such as parallel offsets, multi shot bends, concentric bends, ect.
The bends are symptomatic of what?
The bends are also known as decompression sickness.
When was The Bends created?
The Bends was created on -19-11-08.
What is it called when a wave bends around an obstacle?
When a wave bends around an obstacle, it is called diffraction.
