0
What else can I help you with?
What is rj connetcter?
RJ stands for registered jack. There are a no. of RJ's that we use for e.g., RJ-9 ,RJ-11 RJ-12, RJ-45, RJ-48 etc
What happened at the end of rj Berger?
RJ left the Winter Formal and went to have sex with Lily in her hospital bed. After so, RJ leaves and Lily flatlines, with all the nurses rushing to her room. The episode ended with a cliffhanger so you watch Season 2.
What does RJ mean in Chinese?
RJ in Chinese means RJ
What are the types of RJ connectors?
There are RJ-11, RJ-12, and RJ-45 connectors. RJ-11 is typically used for telephone lines, while RJ-45 is used for NICs.
What nicknames does RJ Vaughn go by?
RJ Vaughn goes by RJ.
What nicknames does Rj Revilla go by?
Rj Revilla goes by RJ.
What is the meaning of RJ in RJ 59?
RJ-59 is a type of connector and RJ here refers to Registered Jack.
Why Do You Want To Be A rj?
rj what the freak is dat r u talkin about rj berger lol =P
What is the meaning of DJ or RJ?
DJ & RJ are different DJ - Disk Jockey RJ - Road Junction.
How tall is RJ Magee?
RJ Magee is 6'.
Is RJ Reynolds single?
No, RJ Reynolds is not single.
What are the similarities between rj 45 and rj 15?
Differences between RJ-11 and RJ-45: • RJ-11 (connectors) have positions for 6 wires (3 pairs), used primarily used for voice transmission over typically 2 ranging up to 6 of the wires. • RJ-45 has 8 wires (4 twisted pairs), primarily used for data transmission over 4 to 8 wires. • Connectors are physically different sizes. That said, they have many similarities as well. Some you may not have thought of: • RJ-11 and RJ-45 both have pin spacing that is identical. This is by design. • RJ-11 and RJ-45 both have connectors of identical height. • RJ-11 and RJ-45 both use the same shape and size centralized plastic locking pin. Thus, the only sfdifference being RJ-45 allows for 2 extra pins and is a slight bit wider. So In a pinch, an RJ-11/14 6 wire cable can be used to connect two RJ-45 devices provided that that RJ-11 cable has all four or six wires and the RJ-45 socketed devices are only 10 or 100-base-T (sub gigabit) devices as they only use 4 wires. Gigabit devices require use of all 8 wires so it doesn't work for 1000-base-T devices. Also, if the RJ-11 cable is flat-wire (not twisted pair UTP) then the run will have to be very short due to noise considerations. This makes it harder to achieve full speed on 100 Megabit class connections.
