answersLogoWhite

0


Best Answer

TPX-basic cost is $219, and extra magazine are $15.

The TPX Has the CO2 stored under the barrel and only paint balls in the magazine.

It also has an A5 threading which can accept any A5, X7 or Prolite barrel.

T8- basic cost $185, extra magazine $40.

The T8 has CO2 cartridges in the magazine as well as paint.

It has an un-threaded push and twist barrel witch has almost no after market barrels.

The T8 can be converted to shoot first strike rounds or bought with the kit as the T8.1.

I personally would go with the TPX, because instead of having to waste a CO2 cartridge for each magazine, you can fire about three lighter and cheaper magazines. Also the TPX only pierces the CO2 cartridge when the trigger is pulled the first time, so you can carry the marker with the CO2 and magazine in it without loosing any air.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Which is better tippmann tpx or t8 and what is the difference?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the strongest back up gun?

Generally, you should never need a backup gun in game. However if your primary breaks, its best to have either a quick replacement, usually a rental type like a Tippmann 98 (or your first gun) for the next game. If you're referring to sidearms, the best pistols are the Tippmann TPX (my preference and the T8. Its really a decision between having co2 in the gun separate from the magazine (tpx) and having the co2 in the magazine (T9/8). This means that you get full use of the co2 in the TPX, but you also may have to load two separate things. Also the TPX magazines are cheaper due to them having no valves or pipes.


Whick is better tippmann tpx or Tiberius t8.1 or the t9?

TPX-basic cost is $219, and extra magazine are $15. The TPX Has the CO2 stored under the barrel and only paint balls in the magazine. It also has an A5 threading which can accept any A5, X7 or Prolite barrel. T8- basic cost $185, extra magazine $40. The T8.1 has CO2 cartridges in the magazine as well as paint. It has an un-threaded push and twist barrel witch has almost no after market barrels. The T8.1 comes with a first strike conversion kit T9- basic cost $250 The T9 is a T8 with a stock, long barrel, and handgrip. I personally would go with the TPX, because instead of having to waste a CO2 cartridge for each magazine, you can fire about three lighter and cheaper magazines. Also the TPX only pierces the CO2 cartridge when the trigger is pulled the first time, so you can carry the marker with the CO2 and magazine in it without loosing any air. Also the TPX is the only one of these that can use a remote line in the actual gun, not just the magazines. The T8 is an inferior pistol and the T9 is a main gun.


What is the difference in the t8 and the t5 lightning fixtures?

I will assume you mean fluorescent tubes They are different caps


Is the tippmann 98 custom a good paintball gun?

Really any .68 low-mid grade paintballs will work. Buying really cheap paint like inertia and monster will not be accurate, but is very affordable. Mid grade paint ($40+ per case) is the optimum paintballs for any Tippmanns. Any high grade paint (brittle and expensive) will most likely break inside low grade mechanical markers.


Is a T8 ballast and T8 bulb more efficient then a T12 ballast and a T8 bulb?

In a T* ballast and T8 bulb more energy efficient then a T12 ballast and a T8 bulb? A:Depends on the CURRENT through the tube. When the Tube is run at 100% of rating, The T12 Takes more CURRENT to give a certain Brightness. Because the surface of the T8 is closer to the ion stream through the tube, it takes less CURRENT to light up the T8 to the same brightness. However, IF you use a T12 in a T8 ballast, you will get LESS CURRENT through the tube, and LESS POWER consumed ALONG with LESS Light.


How do you find T8 sec x cos x?

If cos(x) = 0 then the expression is undefined. Otherwise, it is T8.


What is T8 stands for T8 lamps?

Fluorescent tubes are measured in 1/8ths of an inch. A T8 would be 8/8ths or one inch. Likewise a T12 would be 12/8ths or one and a half inches.


What are the differences between LED tube T5 and T8?

LED tube T8 is much coarser than the LED tube T5 T8 is about 3 cm in diameter ,the diameter of T5 is about 1.5 cm. LED tube T8 Power : 36W (120 centimeters ) 30W (100 centimeters ) 18W (60 centimeters ) LED tube T5 Power : 28W (110 centimeters ) 21w (88 centimeters ) 14W (55 centimeters ) 8W (30 centimeters ) The distinction between T8 and T5 LED tube lamps, and their advantages and disadvantages : The difference between T8 and T5 is the thickness , T8 circumference is 8 cm , T5 circumference is 5 cm . The LED tube T5 has less light decay, longer life, but the lower electro-optic efficiency (the emitted light consuming 1W power ). The LED tube T8 has the more light fades , shorter life, but the higher electro-optic efficiency (the emitted light consuming 1W power). The diameter of LED tube T8 is 24MM LED tube T5 is 16MM in diameter Regular LED tube T8 diameter is 1 inch , 1 inch = 25.4mm, 25.4mm multiply 3.14 = 80mm = 8cm, ie 8 cm .LED tube T5 is 5cm


Difference between T12 and T8 fluorescent bulbs?

A T8 lamp can be retro fitted into a T12 fixture by replacing the T12 ballast with a T8 ballast. The end sockets also have to be rewired in the retrofit as the wiring from the electronic ballast to the sockets is completely different.


How much area will a 2 tube 4' fluorescent light fixture cover?

Depends on how high it is off the floor. Make sure you buy a T8 and not a T12. The T8 puts out more light and will operate at a lower temperture. On a normal 8' ceiling a 2 bulb T8 will cover around 36 square feet of space. If the room is pretty large then an 8 foot 2 bulb HO light is a much better choice.


Can you use a 4ft 4 lamps T8 ballast to run 4 18in T8 lamps?

You need to match the specification for the T8 lamps in question with the ballast. There are some times form factor issues and other times the specific requirements for the lamp in question.


Will a T8 fluorescent bulb work in a T12 fixture?

no