0
The steerer tube is the part that goes from the fork crown, up through the frame and connects to the handle bar.
The head tube is the most forward part of the frame the part that the steerer tube runs through.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Is the head end of a tube the closed end?
The head end of a tube can be the closed end. This depends on what the tube's purpose in the car is.
What is a spark plug tube seal?
For Hemi heads where the spark plugs are in the top of the head and there is a tube in the valve cover where the tube meets the head is the tube seal. It is basically an O ring.
What other year steering column fits a1983 camaro?
need to replace stearing colum to its original stearing colum
What is a head tube on dirt bikes?
The head tube is the most forward part of the frame, the bit that the front fork goes through and turn in.
What is a dolphins fins for?
They are for stearing gliding in water
Why was Chevy Cobalt discontinued?
power stearing
How do you ride a 24 inch bike?
The four most common measurements are:center-to-center from bottom bracket to top tube, measured along the seat tubecenter-to-top from bottom bracket to end of seat tubetop tube length measured center-to-center from seat tube to head tubeor, for bikes with sloping top tubes, a virtual top tubeis given, measured from center of head tube to where the center of the seat tube would be for a horizontal top tubeFor some reason, road bikes are sized in cm while MTBs are traditionally sizes in inches.Then there is a bunch of other measurements, chain stay length, head tube length, seat tube angle, and head tube angle.You also have the diameters, Head tube inner diameter, seat tube inner diameter, bottom bracket threading/diameter. Use a vernier caliper
What is an Internal Headset?
An internal headset is a headset where the cups that make up the bearing races sit inside the head tube w/o protruding, making them almost visible. They need a fairly thick head tube to be used. For bikes with narrower head tubes the widest parts of the bearing cups mushrooms out over the head tube.
Problems with abs and braking 2001 Chevy astro van?
i have shevrolet astro 2001 hydrolic stearing when i aply brake and turn steating system it gets hard and the same time it makes sound as if there is no oil i have changed hydrolic booster and the stearing pump and stearing box and the main pipe lines too but still when im at idle with brake eplied and turning the stearing to left it will get stuck and as soon as i remove my foot from the brake padal then stearing weal can contenew to turn to full turn so pls help
Where is the horn on the 1999 Mazda Protege?
in the stearing wheel
What kind of simple machine is a stearing wheel?
a lever
Why is there floating head in heat exchanger?
allow for tube expansion
