0
It is referred to as a false start.
Wiki User
∙ 7y ago
Add your answer:
Earn +20 pts
What is the difference between multichannel and multidimensional signals?
if a signal is a function of single independent variable,then signal is called multichannel signal. if a signal is function of multiple independent variable then signal is called multidimensional signal.
Why it is called as delay circuit?
because it delays the input signal by some time interval before it appears on the output.
What is the starters command signal in swimming?
In heat one: one long whistle means for the swimmers to , then the official says "take your mark". A gun, whistle, or beep may be heard as the signal for "GO". In further heats: as the last swimmer from the heat before reaches the flags, 3 short whistles are heard to signal the next heat of swimmers that it is time for the next heat to get ready. The same commands as above then apply.
What is it called when you convert a digital signal to analog?
When you convert digital signal to analog, it is called as an analog signal. The device used is called digital to analog converter.
What is unmodulated signal from a transistor is called?
When the out from a transistor is the exact replic of the input signal then it is called unmodulated signal i e. there will not be any change in frequency voltage power etc
What term descries a chemical signal made in sweat glands?
You are describing what we called pheromones. These usually are not made much before the age of puberty.
Do you turn your signal on before or after if there is a street before a stop sign in Nv?
after
Would trees block a sattellite tv signal?
if tere are enough branches in the way - yes. --------------- At my friends house he can receive satellite in the winter when there are no leaves on the trees.however when the trees leaf up in the spring the satellite signal is too weak to be of any use...Come the fall, when the leaves drop, the signal comes back and his satellite works again.
Why should signal repeaters be placed before the end of the maximum distance for the cable?
So that it doesn't lose the signal completely before reaching the repeater.
Why should a signal repeater be placed before the end of the maximum distance for the cable?
So that it doesn't lose the signal completely before reaching the repeater.
Name the process in a radio which make the signal stronger before the loudspeaker changes it to a sound signal?
Amplification.
When several signals can be transmitted at once it is called?
When several signal transmitted simultaneously. this is called multiplexing of signals.many signal are combined into one and then they transmitted.
