answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the difference between a spline shaft and axle shaft?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the purpose of inter axle differential?

The inter axle differential (also called a power divider) is an integral shaft in the forward axle. That shaft is the input for the forward axle and also the rear axle with a differential separating the input from the output allowing for a difference in speed between the front and rear axle.


What is the purpose of inter-axle differential?

The inter axle differential (also called a power divider) is an integral shaft in the forward axle. That shaft is the input for the forward axle and also the rear axle with a differential separating the input from the output allowing for a difference in speed between the front and rear axle.


What is an axle spline?

Splines are parallel grooves on the side of a shaft that engage with matching grooves in a socket. They allow power to be transmitted between two rotating elements. Splines are used on axles to allow them to be removed and replaced.


How do you tell if you have 31 spline axle?

Count the splines.


What is the torque value for the rear axle nut in a 1987 Corvette?

180 torque lbs too much and you F up the hub Bearing BE CAREFUL !! PS when sliding the 1/2 shaft spline in the bearing It is best to FREEZE the SPLINE in the refrigerator this shrinks the spline and slides in MUCH BETTER DO NOT BEAT IT IN !! you can damage the bearing like that !!


What spline axle does a 1984 f150 have?

It will either be a 28 or 31 spline. I believe that most open rear ends used 28 spline and the limited slip rear ends used 31 spline.


What causes a leak where the axle meets the transmission on a 1996 Grand Caravan?

Axle shaft seal.Axle shaft seal.


What size is front ring gear in 1992 Chevy pickup?

The size of the front ring gear in a 1992 Chevy pickup is 7.5 inches. The 7.5-inch ring gear needs a 26 spline axle shaft.


What is the part between the axle and the trans referd to as on a 95 integra?

its called the intermediate shaft


What is the difference between a single axle and a tandem axle?

vkbvbp;.v;xcmvimv,


What is the difference between a pusher axle and a tag axle?

a pusher axle is in front of the drive axles, a tag axle is behind them


How do you pull out Driver side front axle on 1991 Toyota Camry 2.0?

It acts like it is stuck,And I have to be carefull not to grab the boot and pull on it.I'm just pulling on the metal bearing cup with the spline towars the transmission..Should I try and pry it with some kind of bar,Or is that metale ring at the end of the spline holding the shaft in?