0
Add your answer:
Earn +20 pts
What does the letter l mean in t 6.3al250v?
6.3AL250V are markings on a fuse. 6.3 (A)mperes (L)ow Breaking capacity 250 (V)olts
What are some pros and cons of being a fashion coordinator?
Pro: Up with the lastest fash and can tell everyone about it Con: lots and olts of work being a coordinater. Good luck with whatevs you choose xx
Why are you only getting 8 v olts at fuel pump on 1996 Chevrolet s10 pickup 4.3?
Be sure the grounds are clean and tight, and I am assuming the battery is good and is fully charged (12.68 V)
What is the amperage rating of an 2800 VA computed load connected to a 120 volt single phase branch circuit?
Consider the 2800va (v)olts x (a)mps the same as 2800 watts (at unity power factor). The formula for amps is A = W/E, 2800/120 = 23.33 amps.
How do you change glow plugs in a 1996 Ford F-250 power stroke diesel?
To remove glow plugs on 1996 ford powerstroke. First yhou must remove the air tube to the turbo so you can get to the olts that hold the valve covers on. YOu must remove the valve covers on both sides once they are removed you have a wide open shot at getting the glow plugs out.
What is the depth requirement for an under ground electric house wire?
It depends on the voltage and if it is a branch ciriut or a service. If it is under 30 v olts 6 inches will work. If it is 120 volt branch circiut it needs to be on a GFI, on a 20a breaker and either in a condiut or uf cable to be 12 in . If it is not on a gfi , and it is over 20 a then it must be 18 in. Regardless the wire must be in condiut or be of UF cable to make it water tight.
What are some seven letter words with 4th letter O and 5th letter L and 6th letter T and 7th letter S?
According to SOWPODS (the combination of Scrabble dictionaries used around the world) there are 5 words with the pattern ---OLTS. That is, seven letter words with 4th letter O and 5th letter L and 6th letter T and 7th letter S. In alphabetical order, they are: abvolts lavolts revolts unbolts uncolts
What are some seven letter words with 1st letter L and 4th letter O and 5th letter L and 6th letter T and 7th letter S?
According to SOWPODS (the combination of Scrabble dictionaries used around the world) there are 1 words with the pattern L--OLTS. That is, seven letter words with 1st letter L and 4th letter O and 5th letter L and 6th letter T and 7th letter S. In alphabetical order, they are: lavolts
Difference between ac and DC?
the difference between ac and dc is ac current changes its direction after every fixed interval of time.In India it changes after 1/100th second. and in dc it does not changes its direction.... --- Note: while in India and most European countries it changes 100 times/second (50 cycles/second), in the US, the standard is 60 cycles/second (or 120 changes/second). You will also see this called 60Hz in the US. In the US, the nominal standard is 120V, meaning it will go fromm +120V(olts) to -120V, then back to +120, (a full cycle), 60 times/second. In Europe the standard is 240V @ 50Hz. As far as average available voltage: 120V AC = 60V DC (because the 120VAC goes to 0 twice a second as it cycles up and down).
What actors and actresses appeared in Once Upon a Time in Ottawa - 2003?
The cast of A Passage to Ottawa - 2001 includes: Dan Beamish as Pilot Robert Brewster as Paul Franceen Brodkin as Maggie Jim Codrington as Roland Alison Darcy as Hippy Girl Marion Finklestein as Airport Attendant Didier Garrett as Adam Karina Griffith as Girl at bus stop Alyssa Lawrence as Julie Penny Mancuso as Policewoman Kent McQuaid as Party Philisopher Nabil Mehta as Omi Robert Norman as Lieutenant John Olts as Man in telephone booth Anana Rydvald as Female Tour Guide Pierre Sigouin as Attractive tour guide Ivan Smith as Jalal Amy Sobol as Safia Jesse Todd as Hippy Guy
How do you drain the auto transmission fluid in a 2001 Hyundai Sonata 2.4L?
TAke the pan off and also change the filter while you are in there. 1. Ensure the vehicle has been warmed up by driving at least 10 KM. 2. Raise the vehicle at the front (orefereably on ramps) by at least one foot (30cm), 3. Ensure the vehicle is secured with handbrake and chocks under rear wheels so it cannot move. 4. Remove the transmission dipstick to allow an entry path for the air into the transmission. 5. Affter placing a suitable pan of 5 litres capacity under the transmission undo the drain bolt from the transmission pan (if it has a bolt one) allowing the oil to drain out into the pan. (a cheap pan can be made by cutting a large hole in the side of a disused plastic qol container) 6. Restart the engine in park and move into dreive and then reverse for a few seconds - this should allow more oil to drain out. 7. Now carefully remove all the bolts from around the side of the transmission oil pan and allow it to to fall gradually - then more oill will flow from around the edges. Just keep a few rags present to mop it up. 8. If the pan does not self release carefully prise it loose with the persuasion of a flat screw driver. 9. This pan should cantain several metal disk magnets (about 2cm across)in the bottom which collect any ferric metal filings which have worn off the internals. (hopefully not large ones which indicated it is on the way out). 8. It also contains a flat type filter which should ideally be be replaced or at least cleaned in a thin oil flowed by a bath in new Dextron 11 or better auto tranmission oil. 9. At this time after examination of the pan contents to ascertain if any sludgy material is present. You should decide if a full change of all the oil is warranted since this method of draining does not remove all of the fluid because some is still stuck in the torque converter and must be removed by an other more comprehensive method. However this method described here is sufficient for normal changes. You shold then clean the pan thoroughly and replace the magnets after cleaing them of any metal filings. 10. Relacement is the reverse of disaassembly. Be careful not to cross thread or over tighten the olts holding the pan and be sure to use a clean new gasket. Remember the casing material is an ally and bolts can be easily cross threaded or over tightened max pressure about 8 foot pounds (10 newton meters). you can easily tighten a loose bolt if leaking is a problem but one stripped threads are more of a problem. 11.Make sure you tighten the drain plug to 22 to 25 Foot pounds (30 to 35 NM). 12. Refil the auto tranmission through the dipstic tube (use a suitable funnel)with about 3.5 litres of Dexron 11 or 111 auto transmission oil and start the vehicle in Park. Then check for leaks and measure the height on the dipstick. Add more fluid up to about 4.2 litres but be cautions since the vehicle is not yet on level ground. Don't overfill. Lower the vehilce and check again for leaks and level after moving the transmission through each gear. 13, Road test the vehicle and after it is warm check the transmission level again for the correct level adding fluid if necessary. This chech should be done with the transmission in Park and engine idling. I have found this method to be successful hahving done the last two transmission oil changes (30,000 KM each). Oil is clean and red after the changes. (cost of oil Austalian $25 , New filter about $20.00) Time about 1 hour. If you are unhapy and find it is still dark after the change either change it again in another few thousand km whereupon it should be as good as new or flush it completely by the following method. Happy motoring. P.S. if the whole of the fuid must be changed because of suspected contamination with incorrect fluid or for other resons it is desireble to fully flush the oil. It can be done by unbolting the transmission oil cooler line at the point where it connects to the oil cooler. After draining and refilling the transmission with new fluid and before operating the engine. A clear line an be connected to one end of the oil cooler line draining into a separate container and the other end immersed in new tranmission fluid. ON starting the engine the transmission will pump the trapped old oil from the torque converter thru the oil cooler line into the container. An assistant will be able to tell when the new oil appears by thee change in colour from bronish to bright red.n, upon which the engine is immediatly shut down. All of the old oil will now be replaced by new oil. The oil line can be then re connected. A transmission shop will usually charge about Australian $130 to $160 for the job - full flush is an additional charge.) Dispose of the oil at your nearest approved disposal site.
