There are brass,tungsten,tungsten alloys(w,Ni,Fe,w,Ni,Cu)used to make a barrel
a poison dart frog obtains its materials by eating it
Yes
Chances are your Maverick failed to fire and the dart is stick in the barrel. If you can, remove the dart. If that isn't the problem, there might be some other obstacle inside your gun. Try unscrewing it.
The 60 cal. has a bigger barrel.
single shot 30 30 with 32 gauge dart barrel have barrel need action
yes it can
well you can use almost all dart but clip system dart shoots like 9 feet flat
The Longshot's barrel extension does decrease the firing range, by roughly five feet. This is because the elongated barrel causes more friction with the dart as it travels through it.
Position the dart within the barrel, then proceed to pull the top section backwards until you hear a click. After this preparation you may activate the trigger, releasing the dart.
Without modification, I've found that the increased drag it causes actually reduces the overall range of the Longshot.* EXPLANATION *As is easily seen, the longshot's barrel is much wider than the nerf dart, and all the pressure from the gun's piston is gone long before the dart clears the barrel. Most, if not all of the dart's momentum is gained in that bit of tube that "chambers" the dart (remove the magazine and slide the bold forward, then look in the magwell (magazine slot), it's that orange pipe), and the rest of the barrel doesn't do much besides making the dart fly a little straighter.* OPTIONAL SOLUTION *If you don't mind getting your hands dirty (metaphorically speaking), remove the air restrictor (look up a few walkthroughs on the 'net) and insert some closer-fitting pipe (in a similar manner as the inner barrel of an airsoft gun) to use as a functional barrel (again, I recommend looking up guides on the web).
you put the primer forward to create elastic potential the put the trigger to turn that to kenetic and sound energy
You take of the barrel exstension and open the top hatch. If you can't get the dart out then, take out the clip and use your fingers to get it out.