0
it will take any 2 stroke oil just mix it with petrol with a ratio of 25/1
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Is the 1987 Suzuki Quadrunner 230 a 2 or 4 stroke?
The 1987 230 was a four stroke. They had several variations including a quad sport with a manual clutch. They were very strong quads, I regretted parting with mine in a trade for a king quad 4x4. I liked the lighter 230s much better. Take care.
How do you change the oil on a 250 Suzuki Ozark?
Under the quad, at least on the 2003 and 2005 suzuki ozark 250 quad runners, it is under the quad, there is a 17mm bolt that is the only bolt accessible under the quad, take that out and it drains it.
How do you take apart choke cable assembly on suzuki quad runner?
how to change choke cable
How do you reset codes for suzuki king quad?
Take the battery cables off for a few min.
What oil type does a suzuki zillion take?
semi sinthetic 2 stroke oil
How much engine oil does a kawasaki ksf 250 four stroke quad need?
Most models take 2 Liters.
How do you change oil on a ozark 250?
under the quad atleast on the 2003 and 2005 suzuki ozark 250 quad runners, it is under the quad, there is a 17mm bolt that is the only bolt accessible under the quad, take that out and it drains it, i am trying to find out where the oil filter is located, if you know please email me, crazyandy052@yahoo.com
How do you set a clutch on a suzuki eiger 400 quad with manual transmission?
I'm fixing to figure it out Tommarrow when my kit gets here i may take pictures of the process.
How do you derestrict suzuki lt 50 quad?
Take the washer out in the exhaust Regards, Crimpy There is also a re stricter in the intake....pull the carb...and remove resricter plug. Sniffer.
Where is the neutral switch located on 1997 suzuki king quad?
If you take off the back fenders and the rack then take the intake off then you should be able to spot a small black thing with a wire leading off of it. Thats the sensor.
How do you replace front hub on a 1987 suzuki quad runner ATV?
take the cotter pin out of the front axel shaft then take that castle nut off and the hub should come off it might need some taping with a hammer to get it broke lose from corrossion
What 4 events take place in a stroke cycle?
Suction stroke, compression stroke, power stroke & exhaust stroke
