answersLogoWhite

0


Best Answer

Pin 1 - Battery +

Pin 2 - Battery -

Pin 3 - Output Signal - May not be needed

Pin 4 - Keyswitch. Turns display off when key is off. Can be wired to Battery + if you want it on at all times.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Trying to wire Curtis 906 fuel gauge to Yamaha drive golf cart?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is drive gauge in kingdom hearts 1 and how do you increase it?

There is no drive gauge in KH1. Ventusisawesome@khmail.com


What features does a Yamaha Zuma have?

A Yamaha Zuma comes with a lot of features. Some of these features include speedometer, storage options, fuel gauge, clock and a digital odometer. A Yamaha Zuma is a very popular brand.


What is the proper spark plug gap for a 1999 Yamaha blaster?

The spark plug gap is .020 on your gapper gauge!


Where is the oil dip stick on a Yamaha XVS650 motorcycle?

There is no dipstick. There is a sight gauge on the bottom left side of the crank case. There is no dipstick. There is a sight gauge on the bottom left side of the crank case.


Valve clearance Yamaha YFM 200?

intake is .002 to .004 exhaust is .006 to .008


Is it ok to drive vehicle with broken oil pressure gauge?

sure


What makes the oil gauge to flop back and forth?

if you are talking about the pressure Gauge it is becouse your car is bumpy or you drive too fast


Where is the S Gauge Wisconsin in Madison Wisconsin located?

The address of the S Gauge Wisconsin is: 118 Shiloh Drive, Madison, WI 53705-2433


Why does your battery gauge run low?

my gauge reads 10 volts drive half mile it go to 8 Alternator is defective and needs replacing.


Where is the best place in kingdom hearts 2 to level up your drive gauge?

Kohinoor


Why does your amp gauge move up and on your harley?

There is a simple reason for this. The amp gauge should move up and down as you drive it's simply showing what the bike is pulling.


What wiring kit i use for Crunch drive v4300 watt1200 amp?

i would say a 4 gauge kit would be more then enough for it 8 gauge min...