thanks :)
One needs a clutch kit once he or she notices that the clutch is slipping. It is better to change it than be stuck in the middle of the road with a faulty clutch.
replace the whole thing. you can do a new one or get one from a junk yard
No. Clutch is what disengages the motor from the transmission. Shift would be changing gears. You should depress the clutch to shift from one gear to another.
Your clutch needs adjusting refer to your manual if you have one.
The best thing to do is find the 2 adjustment screws for the clutch which are located attached to your clutch lever housing and on the clutch cable. Turn them outwards (lossen them) so that it tightens the cable and spreads the clutch plates apart, remember that you should end up with a gap (about the thinckness of a nickel) where the clutch lever and the housing rest as not to have your clutch partially engaged. If that is not enough and the bike wants to surge forward a bit then just adjust one of the screws (usually the one on the cable) until the clutch completely disengages the plates and the bike should not surge forward at all.
shaft should only spin one-way
Clutch bags are very fashionable at the moment and they are stocked in several stores. Affordable clutch bags can be purchased at H&M, whilst a better quality bag could be obtained from Sears.
A Coach clutch can be purchased directly through Clutch at one of their retail locations. One is also able to order a Coach clutch directly from the Coach website.
what is the job of a one-way clutch
It's right underneath your clutch pedal. If you take a flashlight and look at where your acceleration, brake, and clutch are, you'll find that each of these has a fuse. The clutch fuse has a little rod that gets pushed in against a spring, and the fuse should have two wires, one black one red, running from it up into your car.
You need to buy a puller ,one for the drive clutch [ on the motor ] and one for the driven clutch .That drives the ATV ! I bought mine from Dennis kirk for 60.00. Take the bolts out of center & put the puller in & tighten puller, they should come off
Not on the clutch itself but on the clutch pedal there is one for starting.