Need to know what kind of headset you've got to be able to answer that. If it's a threaded headset with a quill stem you just need to undo the screw a few turns, then tap the screw down. After that you should be able to pull the stem out and undo the fork by removing the locknut and then the top headset cup.
If it's a threadless fork the compression cap should come off after undoing the top screw, after which you can undo the stem bolts, slide the stem off and the fork should come right out. If something really strange has happened to your compression cap bolt you'll simply have to cut away the compression cap to get the fork out. They're usually quite soft, some are even plastic, so it shouldn't be too bad.
The question is a bit unclear. Usually it's not the fork that's integrated, but the headset. And integrated headsets will only fit in a special kind of head tube not usually found on a standard frame. Forks OTOH can usually take more than one type of headsets.
any forks with a 1 1/8" steerer. and i do mean any.
A BMX stem is what connects the handlebars and forks to the frame.
Assuming that you are referring to a bicycle, this is what you will need: -frame -handle bars -headset (the bearings and bearing races that let your forks turn inside of the head tube) -forks -seat and seat post -crankset (the inside workings of the crankarms and pedals), crankarms, and pedals -sprocket, hubgear, and chain -brakes and brake cable -rims, tires, and inner tubes and grease
To replace fork seals on a 1968 Triumph 650, you need to remove the front tire so that you can access the forks. The next step is to loosen the clamping bolts where the forks connect to the frame. Use the right amount of fork oil required in the owner's manual. Replace and tighten the forks.
preferably affortable but also light
A heavy frame with a lifting mast and forks in front
The headset is a set of bearings that allows the fork to turn smoothly in the head tube of the frame w/o sticking wobbling around when you turn the handle bars.
working from back to front: tyre, innertube, rim, spokes, nipples, hubs, frame, cranks, pedals, sprocket, seat clamp, seat post, seat, bars, grips, bar ends, stem, headset, top cap, forks, hubs, spokes, nipples, rim, innertube, tyre :)
The headset on a bicycle provides a rotatable interface between the bicycle frame and the bicycle fork. It is a set of components that consists of two cups that contain bearings, they ensure smooth steering.
Any 20inch forks will fit.
The forks are the parts of the bicycle frame to which the wheels are attached.