0
What else can I help you with?
How do you find the highest point on a long floor?
Take a long piece of string or twin that you can pull tight. One person go to one corner, or side, of the room and the other opposit of them. Press the string down on the floor and the other person pull tight while pressing their end of the string on the floor. By pulling tight is should show where the floor is and isn't touching the string.
How is a line level used?
A line level is used on a piece of string usually. Hold the string tight on one end and tight on the other. The line has to be completely tight or it wont read properly. You can either accomplish this with two people or so or by using nails and tieing the string tight around them. You adjust one end or the other until the bubble is in the middle. Good luck.
What classical guitar string has a wound first string?
Clearly a Rocky Horror related question... as in "Wound up like an 'E' or first string." 6-string guitar has a high E string wound up nice and tight.
How do you make lanyards?
first you take one string and cross it over then do the same to the other then take the other coler string and go through the back hole make shure there is space for another string for the other hole then take the other same coler string and go through the one you havent gon through then pull relly tightly and make shure that all string is tight and straight.Thank You For Your Time
Does sound travel better through tight string or loose string?
check my answer
How do you make a Chinese ladder bracelet?
First, you get two pieces of string. You tie a tight knot and tape it to a table or flat surface. Then, you take one string and cross it over the other, making a shape like the number 4. You then pull it tight to make a knot. You keep doing this until you want to switch. Then, you switch the use of the string and do it until you finish all the bracelet. Tie around your wrist in a knot.
Why should the string be tight in the string telephone?
If the string is not taught (strung with tension that holds it up and with little sway) then the sound wave would have too much resistance as it tried to pass through the string which would prevent it from reaching the other end.
How can I effectively tie two strings together?
To effectively tie two strings together, follow these steps: Lay the two strings parallel to each other. Cross one string over the other to form a loop. Wrap the end of the first string around the second string and pull it through the loop. Pull both strings tight to secure the knot. Trim any excess string for a neat finish.
How to tie a guitar string securely?
To tie a guitar string securely, first thread the string through the hole in the tuning peg. Then, wrap the string around the peg a few times, making sure it is tight. Finally, use pliers to bend the excess string at a right angle to secure it in place.
How do you tie acoustic guitar strings?
To tie acoustic guitar strings, first insert the end of the string through the hole in the tuning peg. Then, wrap the string around the peg and pull it tight. Finally, tune the string to the desired pitch.
Did Frank Thomas start at tight end for the Auburn Tigers?
Yes, played only as a freshman, catching three passes for 45 yards as a tight end...
How can you create a walky talky?
take two empty soup cans, a small nail, a hammer, and a long piece of string. punch a hole in the bottom of each can. stick one end of string thru one can, and tie a knot in it. stick other end of string thru other can. knot it as well. stretck string tight and speak into one can. other person will hear you voice in other can.
