0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the stereo from a Toyota Previa?
I would advise you to check out the Previa site on yahoo. It is an excellent site. Check this site it out http://tarago.blogspot.com/ , it helped a lot.
What would cause my1995 Toyota Previa to hesitate during acceleration with no power?
Start at the fuel filter. It may be clogged.
How do you charge your air conditioner on your 1991 Toyota Previa and what kind of freon do you use?
Would have been built for R12, can be converted to R134a.
How do you remove the wiper arm from a Toyota Previa?
Unless the actual arm is broken, I would just replace the rubber. You can order it from Toyota, and its way cheaper than a whole wipe arm.
1999 Toyota Tacoma dash light replacement?
my 1997 Toyota Tacoma has the dash/gauge light burnt out - i would like any help to locate bulb and replace i thank you
Can I replace front windshield wiper arms of a 91 Toyota Previa with arms from another make and model Any ideas of what types would fit Also how would one remove the existing wiper assembly?
I would say NO as the lucida and estima and previa are all different in length and width if you can find replacment arms etc from eBay
Is a 2009 Toyota Sienna non interference engine?
The 2gr-fe uses a chain ,not a belt ,and yes if it were to jump the valves would bend
Would a leak in the intake manifold gasket cause low compression?
no it will not. Bad rings will do it, Valves not seating in the head, Bad head gasket. Burnt piston will do it . These are things to look for.
What would happen if you put burnt toast in your toaster?
It would get more burnt
Why would check engine light be on for 97 Toyota Previa and diagnostic reads ABS 2 quick blinks and Cruise 2 quick blinks check engine stays on Why and what does this mean?
get a haynes manual at a library
Why would trasmission fluid smell rotten and burnt?
Cause its burnt.
What may be the causes of no compression in the rear two cylinders?
bad rings most likely burnt valves i would also suspect a blown head gasket between those 2 cylinders
