a couple million.
Id say 150$
500
Rod Ball is 5' 10".
To properly install a pop-up drain ball rod assembly in your sink, first, insert the ball rod into the hole at the back of the drain. Then, attach the ball rod to the lift rod using the provided hardware. Finally, adjust the ball rod and lift rod to ensure smooth operation of the pop-up drain.
When you move the ebonite rod closer to the pith ball, the pith ball becomes negatively charged due to the transfer of electrons from the rod to the ball (inducing a positive charge on the rod). When you move the rod away, the pith ball returns to its neutral state as the charges redistribute.
Rod Ball was born on May 8, 1955, in Miami, Florida, USA.
Assuming the pith ball is uncharged, and the rod isn't touching it: The electron particles on the fur will have come off on the rod, giving it a negative charge. As a result, the pith ball will be attracted to the rod because all uncharged matter is attracted to charge matter.
Need to know upper or lower ball joint and inner or outer tie rod end or all together. These parts are replaced not repaired.
The pith ball will be attracted to the plastic rod because the rod acquires a negative charge when rubbed with silk. This causes the pith ball, which is neutral, to be attracted to the rod due to the opposite charges.
They keep dirt and water out of a tie rod or ball joint, and grease in.They keep dirt and water out of a tie rod or ball joint, and grease in.
The ball joint should be permanently in the tie rod end. If it is bad, you have to replace the entire tie rod end.
yes, because usually metals are positively charged and positive repells positive