Want this question answered?
Replace it with new tubing.
There is a lot of differences between PVC and Fiberglass. Fiberglass is going to be stronger and PVC is the plastic tubing that you find in local home repair stores. PVC tubing is cheaper than fiberglass. Fiberglass tubing is lighter in weight. PVC tubing can be bent when heat is applied, but fiberglass tubing is fixed and will break, not bend.
Cut the dipstick tube with a tubing cutter below broken dipstick and remove Use rubber tubing and hose clamps to reattach tube pieces
Copper tubing that is underground must be one complete piece.No connectors,no repairs.All fittings must be above ground.Also all underground copper tubing must be plastic coated to protect it from oxidation.
Cut the tube with a tubing cutter- remove dipstick and use rubber tubing and hose clamps to reassemble dipstick tube what up.
It isn't dangerous until the glass breaks. Broken glass is dangerous. The contents inside the tubing may contain mercury or other chemicals that should not be ingested.
There is no safe way to repair a broken or leaking brake line. The line or tubing that is leaking must be replaced or a new piece of tube, spliced into the line with fittings, to replace the leaking area.
It uses the same resovoir as the windshield. The fluid is piped to the rear spray via tubing.
In the engine compartment. It is the same reservoir that supplies the windshield wipers. The fluid is pumped to the rear window via tubing.
you have vacuum line off or stopped up going to heater control. Your post led me right to the problem. broken vacuum line under the hood at the canister. I used a short piece of shrink tubing to repair the line.
cause of a fuel leak in the multi port uint ,broken tubing usually.
Normal windshield washer fluid contains methanol. Rubbing alcohol is isopropyl alcohol. Assuming that your rubbing alcohol is 70% alcohol, I would mix 1 cup of alcohol for every 2 cups of distilled water. If you use tap water, you could get mineral deposits in your windshield washer tubing. Also, I wouldn't try using rubbing alcohol in an older car, because it might still use rubber tubing. This would be damaged by the isopropyl alcohol.