when i put my backplate on my shoulder pads there are almost always a hole to put them in or you can tie it to your pads with a shoe lace?
you will need to drill holes in the back of the plate on the shoulder pads, make sure you use the back plate to line the holes up to where you will need them. You will need to use a t-nut, which goes in the back of the shoulder pad so the screw will have something to go into. You will want to use some kind of washer on the screw. Just hold the backplate in place slide the t-nut in the back and put the screw and washer in the opening for the backplate and screw it down.
you will need to drill holes in the back of the plate on the shoulder pads, make sure you use the back plate to line the holes up to where you will need them. You will need to use a t-nut, which goes in the back of the shoulder pad so the screw will have something to go into. You will want to use some kind of washer on the screw. Just hold the backplate in place slide the t-nut in the back and put the screw and washer in the opening for the backplate and screw it down.
pull the brake drum off and replace the rubber pads
snap it on
First you put on your shoulder pads, then you put your elbow pads on, next you put your helmet on, finally put your gloves on then you are ready to play lacrosse.
The right way!
1940s - Shoulder Pads invented for defencemen - not used by all players. if you were looking fo hocky shoulder pads
Shoulder pads of the 1920s were made of leather and were somewhat heavier than the shoulder pads worn today.
suck it up, you don't need one
shoulder pads and shin pads
Brett Favre wears american football shoulder pads.
nfl pads are larger than lax pads