0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Does YouTube have videos on how to make a laser?
There are several videos available on YouTube showing on how to make a laser. For example the video entitled "DIY: How to Build a Burning Red Laser" shows step-by-step instructions - including some final tests.
Which step of the laser process is the last step performed by a laser printing a documemt?
Fusing
Which step of the laser printing process is the last step performed by a laser printer when printing a document?
fusing
What is the step dimension on Ford Laser fly wheel?
Ford KE laser 1988 Flywheel step dimension is .018 to .020 thou
Step of the laser printing process involves scanning the photosensitive drum with a laser?
Writing
Which step of the laser printing proses involves scanning the photo sensitive drum with the laser?
writing
How To Make A Laser?
1. Step 1: Take Apart Your DVD BurnerFirst you'll need a 16X DVD burner.I'm using a LG that I had as a spare. Remove all the screws and take apart the case.Remove the drawer to expose the carriage assembly. That's where you will find the powerfull laser diod.2. Step 2: Remove The Laser DiodAll DVD burners will have a set of rails that the laser assembly rides on.After pulling out the assembly, start removing all the little screws to get to the laser diod. Be careful because the diod is a fragile electronic component.3. Step 3: Disassemble An AixiZ Laser HousingThen you'll need to pick up an AixiZ laser housing.You will have to disassemble it and also remove the laser that comes in the housing.I used the back end of an exacto knife handle and gently tapped out the existing laser diod.4. Step 4: Install The Laser Into The New HousingThen you're going to carefully install the DVD laser into the new laser housing. You're almost done.5. Step 5: Connect Up Your Laser DiodAll DVD laser diods use a similar configuration. Be sure to test your polarity using two AA batteries.Then you're going to solder two longer pins onto the positive and negative terminals onto laser diod.6. Step 6: Add The Laser To The Mag LiteDisassemble your Mag Lite, removing the ring, the inside reflector and of course, the bulb.We'll need to drill out the existing reflector so it sits around the laser housing.7. Step 7: Test It For YourselfNow put everything back together.Load your two AA batteries,And here are the test results.Your new burning laser pointer easily lights a match and pops a balloon in an instant. That's how you turn a mini-mag flashlight to a powerful burning laser pointer.
What is the role of metastable state in laser?
The role of metastable states in circumventing laser pulse jitters in multi-step laser excitation of high-lying Rydberg and autoionizing states is discussed. A case study is presented where step-wise excitation of 3d4d (3)G(3,4,5) states of Ca is achieved despite a large jitter between the laser pulses
How can you make a sentence with the word laser?
The laser reflected off the mirror.
Can you change out a belhousing on a 92 plymoth laser automatic?
yes http://vfaq.com/mods/clutch-1G.html this website has step by step directions
In the cleaning step of laser printing the drum is conditioned to contain a high electrical charge?
False
What is the step of laser printing uses heat and pressure to fuse the toner to the paper?
fusing assembly
