0
Add your answer:
Earn +20 pts
How do you put on lacrosse head that's too big for the shaft?
If the head fits then you just need an electric drill and put the head on. Once you have the head on, drill a screw into the shaft through the hole while applying pressure on the drill. If the head does not fit, Then put a pot of water on the stove to boil. Once it is boiling, dip the bottom of the head into the boiling water for about 8 seconds and then squeeze it onto the shaft. This worked for me with a metal shaft so you could try it with a wooden shaft. Instead of all this you could go to your local lacrosse shop and ask them to do it but it will cost you $$$.
How is the head of a hammer held onto the shaft?
With a wedge in the head of the handle.
How to string a lacrosse stick?
go onto to youtube or buy a manual or have someone do it for you at a lacrosse store.Or you can just find a friend who wont whack you in the head
When a lacrosse ball is knocked loose is that called a fumble?
No, when a ball falls onto the ground in a lacrosse game it is referred to as a 'ground ball'.
What does yellow mean in a lacrosse game?
"Yellow" is a term used in Boys lacrosse which means to slow it down,or hold onto the ball.
Does it hurt to get flipped onto your back in Lacrosse?
No b/c there will be grass there
What part of a dart does the flight fit onto?
the shaft
Can a STX Proton Power head fit on a Brine f22 shaft?
Usually you can fit any head onto any head, try the hot water trick: you put a cup of water in the microwave for 3 minutes, and then stick the throat of the head in for around 30 seconds. then you should be able to slide the head on easily!
How do you use a puller to install a power steering pump pulley?
The puller will not put it back on. It's made to remove it only. To reinstall the pulley requires a bolt about 3 inches long, a nut, and flat washer that fits the bolt. There are threads inside the hole on the end of the pump shaft where you insert this bolt. First place the pulley onto the shaft and hold it in place, then install the bolt into the pump shaft. Then hold the bolt head with one wrench, while you tighten the nut and washer against the pulley with another wrench, and it will push the pulley onto the shaft.
What is a harmonizer?
a mass of balanced steel bolted onto the front end of the crank shaft for a smoother running engine
What do you do after you are at the vent on Game Show Island on poptropica.com?
you get onto the top ridge and push the junk onto the purple shaft and follow the inventor.
How to make a 4x4 onto 2 wheel drive?
Remove the front drive shaft
