Replace the batteries.
You must be signed in to your consoles online engine, such as PlayStation Network or Xbox Live. When on the Red Dead Redemption main menu, click on multiplayer and unless there is a connection error, you should be able to connect
Of course not ! Your phone needs to be on to connect to the apps web-site !
No, always connect the negative last.
Either, your printer port is dead, or you are trying to connect it in a wrong port.
you can connect your psp to your computer and transfer all the files to the psp and that should do it
Remove battery cover and connect charger to side post battery.
CHECK the battery may be its dead check the plug and connect it properly other wise buy new. do not connect it again and again its not save for systm
If the hard drive is still functional, you can connect an external monitor or projector. This allows you to see what you are doing on a different screen, bypassing the dead screen.
That is correct, but using the term parallel is an overly confusing way of saying it. - You should connect positive to positive and negative to negative. This will retain voltage and increase capacity. If you confuse the term 'parallel' with 'serial' and connect them positive to negative and negative to positive, you'd double the voltage and probably kill most if not all of the electronics in both cars.
Connect the red cable to the dead battery's positive post and then connect the other end of the red cable to the good battery's postive post. Then connect one end of the black cable to the negative post of the good battery and the other end to a piece of unpainted metal in the engine compartment of the dead battery's car. Then wait 2-3 minutes and try to start the car.
1. Connect one end of positive cable to "dead" battery post. 2. Connect opposite end of positive cable to "good" battery post. 3. Connect one end of negative cable to "good" battery post. 4 Connect opposite end of negative cable to ground (not battery post) on "dead vehicle. After "dead vehicle starts, allow to run at least three minutes before disconnecting jumper cables. Disconnect the jumper cables in the opposite of connection: 1. neg cable from "dead" ground. 2. neg cable from "good" batt post 3. pos cable from "good" batt post. 4. pos cable from "dead batt" post. If you follow the recommended procedure, you will minimize the risk of "frying" the computer.