answersLogoWhite

0

How do you bolt your scooter?

Updated: 8/18/2019
User Avatar

Wiki User

13y ago

Best Answer

you take a bolt and bolt it.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you bolt your scooter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you put pegs on a scooter?

yes, you need to find a bolt that is quite long and stick it through the holes on the scooter so that about 5 inches of it is sticking out on the side you want the peg to be on, slide skateboard bearings on the bolt and screw a bolt on the end, there you go, a scooter peg.


Does a suzuki SJ50 scooter have a oil drain bolt?

no


Where does the exhaust bolt on to a scooter?

Onto the exhaust port of the engine...


How do you install an exhaust pipe on to a 36cc gas scooter?

bolt it on the motor


How do you take off a scooter wheel?

undo the bolt der but i want to take off my break on my scooter but i dont no if i want to. B:


I cant get my back scooter peg to go on my mgp scooter. i think the bolt on it is too small please can someone help?

i got the same prob


What problems would you have when you bolt a razor pro scooter?

Your scooter will start oozing out poop. So i suggest shooting the poop with a uzi to prevent oozing. Hope this helps :)


How do you bolt a scooter?

their are several videos out on youtube on how to bolt a scooter. firstly its going to depend on what scooter you are trying to bolt. if your going to bolt a razor pro, all you need to do is take out everything that has to do with the folding mech. Then put an 8mm bolt through the bottom most front hole, do not tighten it all the way. Put a 10mm bolt through the slot above that one. before you do it up, take the squaired bolt thingy and put it above the bolt so that it doesn't slide out. next take another 8mm and put it through the rails behind the head tube. after you do that, it should be decently solid, but to make it even more solid your going to have to tighen the head set. in order to do that, you will need to tighten the round part a little bit tighter than what you want it then loosen it as you tighten the bolt over top of it. Sorry if this is confusing but their are videos on youtube explaining each of these things.


Is a Razor a3 a good scooter?

Yes Yes Yes, i have already preordered one, but i have been looking at it on the internet and google and stuff, and i reckon it is alright all you have to do is probaly bolt it and then it is an alright scooter and will be quite stable and strong.is ok


How do you fit Madd Gear scooter pegs on to a Madd Gear scooter?

You take off the wheels bolts then, you put one side of each bolt in each peg and you enter the 2 bolts with the 2 pegs on it like before...


How do you make a kick scooter better?

buy new wheels,one piece bars and evenn get a bolt set to make it even more durable


Do you need scooter forks for your scooter?

yes you do need scooter forks on your scooter