There should be 4 bolts on the underside of the engine mounts used to release the engine from the chassis, you then need to unbolt the remaining half of the engine mounts from the old engine and fit them to the new one (unless of course you have new mounts too) and re fit to the chassis ensuring there is not too much play in the chain. as for the tyres i'd try to get your hands on a tyre changing tool available from ebay, zoomkarts etc, if not just let the air out and persevere with a thin strong metal bar.
you go to the Toyota place
You must separate the transmission from the engine. Then remove the eight bolts that hold it in place. Remove and replace.
To change the thermostat on a 1973 Ford Mustang with a 302 engine, drain the radiator. Locate the thermostat under the upper hose assembly and remove the required bolts. Place the new part in position and replace the hose assembly before filling the radiator.
I just had my water pump replaced. The garage and i had read abiut this before. They need to jack up the engine to remove it and place a new one on. I belioeve gm allows 3-4 hours for this. Thanks
you have to remove the engine (some people will drop it some people will lift it, it depends on the tools you have) then separate the engine and the transmission; replace the clutch(try to get a clutch kit so you can replaced the pressure plate as well) replace/machine flywheel as needed. then put back together, and place the drive train back into the car.
I'm no expert, but the injectors are under the big cover on your engine that says 2.8L Multi-Port FI. It is held in place by Hex or Allen screws. the injectors are very easy to replace, but are pricey.
The place that sells batteries will replace it for you free of charge.
the old prk lamp is hooked with spring pressure,pop it out and the new one hooks in ..engine compartment access is required..
no you will need to change the trans no you will need to change the trans
unscrew old filter casing and pull out old paper filter , install new filter pushing into place, replace oil seal if provided and hand tighten filter casing to engine.
lift it up. replace. place it down. It's quite simple
Disconnect the negative cable from the battery. Disconnect the clutch mechanism. Place the car on a jack and remove the engine mounts. Remove the clutch disk along with the other parts. Replace it with a new one.