Remove the slotted nut, needs a special tool or some can get it off with a punch and a hammer. Trying to put the case with seal on over the slotted nut destroyes the seal unfortunatly
remove clutch cover. remove old belt. install new belt.
Remove the cables from the starter. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.
Remove the starter cables. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.
To replace the rearend gear on the Polaris 325 You have to jack it up and remove the eight bolts that holds the rear end cover on. After you remove it you simply have to pull the old gear out and install the new one.
To remove the started on a Polaris 300 Explorer ATV first open the hood. Locate the started which will be up against the wall near the driver's side and remove the screws. You can now install a new started.
Disconnect - Battery cable Raise and safely secure vehicle Remove 2 mountig bolts Remove wiring harness Remove outer tie rod end remove cotter pin loosen slotted bolt Rap housing sharply w/hammer to release (should pop-up) Remove slotted nut twist and remove starter
Don't do it, it is there for a reason.
remove the spark plugs and crank it without starting it and that should clear out the cylinders then clean the plugs with carb cleaner and install them .then start it . it may smoke for a few minutes.
remove the trim that holds the window in, on the side of window frame there should be a plate, behind this is the counter weight,
How do I remove radio from 2000 BMW 530D SE have found slotted screw behind on/off knob
Remove wheels remove caliper mounting bolts (2) support caliper if "peel" off type they should be free now If not Remove center dust cover Remove cotter pin Remove slotted lock nut Remove lock nut wiggle rotor bearing assembly will fall out remove rotor re-install in reverse order Do not over-tighten lock-nut will cause excessive bearing wear.
Witch black box