0
What else can I help you with?
What do fingerboard washers do?
they go between the truck and the bearing wheel to increase durability
Can a phat master blade fit on a reg master clipper?
YEs but you must install 2 small washers that act as spacers, or the blades will not work....... Check ACE, home depot or your local hardware store for the washers.
How do you fit bmx headset-spacers?
same as normal the barings on 1st then u need the spacers to stop it rubbin the top of the frame
What are the plastic things that come with screws used for?
The plastic things that come with screws are called washers or spacers. They are used to provide a cushion or support between the screw and the surface it is being screwed into. Washers help distribute the pressure evenly and prevent damage to the surface or the screw.
Are all the spacers for laminate flooring the sameor do you have to purchase them for the brand of flooring?
you can use the same spacers as long they are a 1/4 "
What services do the company Bokers offer?
The company Boker's Incorporated is a company based in Minneapolis, Minnesota. They are a metal stamping manufacturer, focusing on precision metal stamping, washers, spacers, and shims.
How many nylon spacers are use for stoplight switch on a 2006 Mercury Grand Marquis LS?
I remember two spacers used.
How do you fill rear windshield washer fluid for a 1999 pylmouth voyager?
Both washers use the same reservoir which is under the hood.Both washers use the same reservoir which is under the hood.
Can you use regular laundry soap in HE washers?
no
How can I properly mount a vise to my workbench?
To properly mount a vise to your workbench, first determine the desired location on the bench. Use appropriate screws or bolts to secure the vise to the bench, ensuring it is level and securely fastened. Consider using washers or spacers for added stability. Test the vise to ensure it is securely mounted before use.
What do washers do for your skateboard?
washers are the small metal rings that go between the bearing and axle, and the bearing and nut.here is an exert from http://www.omnisk8.com.au/factory_bearings.htmMake sure to use "speed washers" and "spacers". Speed washers give a slight gap in between your truck hanger on the inside and your axle nut on the outside. Spacers help to retain the two bearings as an integral unit, it spreads the sideways loads of skating between the two bearings and greatly reduce the chances of your bearings popping from either axial loads or over tightening your axle nuts putting pressure on the internal and external bearing rings.
IS there a way to make your teeth not hurt with spacers?
use some Tylenol
