0
What else can I help you with?
How many coaxial splitters can you use?
It depends on your signal level and the signal necessary for your equipment. Each splitter reduces the available signal level to items that are downstream.
What is a procedure with water displacement?
A procedure with water displacement is a method used to measure the volume of an irregularly shaped object by placing it in a known volume of water and measuring the change in water level before and after the object is added. The difference in water level corresponds to the volume of the object.
What level does ampharos learn signal beam?
Level 42.
A variable known only to the procedure in which it is declared is called what?
a procedure-level variable
If you are conducting a tag-only tagout procedure and you are not familiar with the requirements for achieving an equivalent level of safety what should you do?
contact your Supervisor before proceeding
If a tone or signal were presented at 40dBSL to a listener with a threshold of 40dBHL what is the sound level of the signal?
The sound level of the signal would be 40 dBHL. The dBHL unit is used to specify sound levels relative to an individual's hearing threshold, while the dBHL unit is used to specify sound levels relative to a standard reference sound pressure level. When the sound level in dBHL is equal to the sound pressure level in dBSL, the sound level of the signal is the same as the signal level presented.
What setting is the level at which the compressor will begin to process the signal?
The level at which a compressor begins to process the signal is called the "threshold." When the input signal level exceeds this threshold, the compressor activates and reduces the gain of the signal based on the defined ratio. Setting the threshold appropriately is crucial for effectively controlling the dynamics of the audio signal without unwanted distortion.
Which signal is indicates to the motherboard that all the supplies are proper level?
PG Signal (Gray)- Indicates to the motherboard that all the supplies given are at proper level.
How can a noise gate be effectively integrated into a signal chain to improve audio quality and reduce unwanted noise?
A noise gate can be placed in the signal chain after the audio source and before any effects or amplification. By setting the threshold level correctly, the noise gate can automatically cut off any sound below that level, reducing unwanted noise while preserving the audio quality of the desired signal.
1 What is the difference between a level triggered clock and an edge triggered clock?
in level trigger mode, the input signal is sampled when the clock signal is either high or low whereas in edge trigger mode the input signal is sampled at rising or at the falling edge. lever triggering is sensitive to glitches whereas edge trigger is non sensitive.. example: latch for level trigger and flip-flop for edge trigger
Is step signal is a DC signal?
A: while a step can be of both polarity but it is a level change and it is DC LEVELS
The speed of a T-carrier depends on its?
Signal Level
