0
What else can I help you with?
What is the difference between hole basis system and shaft basis system?
In a hole basis system, the dimensions of the hole are kept constant while the dimensions of the shaft are varied. In a shaft basis system, the dimensions of the shaft are kept constant while the dimensions of the hole are varied. The choice between the two systems depends on the specific application and the importance of the fit between the shaft and hole.
How much dirt would it take to fill a hole 4ft deep by 5 ft wide?
The answer will depend on how long the hole is. The hole has 3 dimensions that determine its volume. You have provided measurements of only two dimensions.
What are the dimensions of a one cubic foot hole?
There are an infinite variety of shapes and dimensions that one cubic foot of space can have.
How much dirt is in a hole 3 ft x 6 ft x 6 ft?
No. There is no dirt in a hole of any dimensions. It's a hole. D'oh....
Is the ozone hole constant over the time?
No the ozone hole is not constant over the time
How much dirt will come out of a hole 33 feet round and 5 feet deep?
None but the hole can be filled in with dirt with the given dimensions.
How would a small hole be classified?
Having no dimensions measuring 6 inches or greater in damage
If it takes two men four day to dig one hole how long does it take one man to dig half a hole?
4 days (someone else's answer)New answer: I was asked this question as a personality test during a job interview. He made it clear that the question was not a math question. So when I had no answer he responded by saying that "you can't dig a half of a hole". I then replied that as an adult when I dig a hole, it is for a specific reason. That reason dictates the hole's dimensions. If I do not dig the hole to those dimensions then it is possible that I have not dug my whole hole and therefore it is possible to dig a half of a hole.
How much earth is in hole 3 in 1 fourth time 6 in1 half ft?
None because otherwise it would not be a hole with those dimensions!
What are the standard pocket hole dimensions for creating strong and secure joints in woodworking projects?
The standard pocket hole dimensions for creating strong and secure joints in woodworking projects are typically 1 1/2 inches deep and at a 15-degree angle. These dimensions help ensure a sturdy connection between the pieces of wood being joined together.
What is the radius of hole?
To determine the radius of a hole, you need to measure the distance from the center of the hole to its edge. This can be done using a ruler or caliper. If the hole is circular and you have the diameter, simply divide that measurement by two to find the radius. If you provide specific dimensions or context, I can assist further!
When a metallic block with hole is heated why does not the material around the hole expand into the hole and make it smaller?
The hole expands along with the material as both are part of the same solid block. The overall dimensions of the block increase uniformly due to thermal expansion without altering the shape or size of the hole within it.
