answersLogoWhite

0

Nissan Pulsar

The Nissan Pulsar was a compact car manufactured by Nissan from 1978 to 2007, when it was succeeded in all markets by the Nissan Tiida. Some of the car’s models were marketed as the Nissan Almera and the Nissan Sunny.

500 Questions

Where to find Nissan sunny engine number?

User Avatar

Asked by Wiki User

where can I find the 1997? Nissan sunny EX engine number

Is a pulsar denser than a neutron star?

User Avatar

Asked by Wiki User

The very definition of a black hole is a stellar body dense enough to have an escape velocity greater than that of light -- in other words, light that comes close enough to its event horizon will be trapped around it forever. If a star dies and it has enough mass to be compressed to a high-enough mass-to-radius-squared ratio to have such a high escape velocity, then a black hole will result. Otherwise, it will become a neutron star -- extremely dense, to be sure, but not dense enough to trap light, and therefore not as dense as a black hole.

What is the radio code for a 2001 Nissan Pulsar Q?

User Avatar

Asked by Wiki User

well unfortunatley I went through the same issue with my Camaro. Every car has it's own special code. ( what happend ur battery died?) Now here is the tricky part you can either try to contact the dealer/ previous owner of the car and see if they have it. If they dont have it then you have to take it to a dealer and they hook it up to a computer and read the code off for you. The good news is after this you will have it. I believe you can also ask them to disable this also.

What evidence can you cite that pulsars are neutron stars?

User Avatar

Asked by Wiki User

A pulsar is a neutron star that rotates and sends a beam of electromagnetic radiation. This is known because only a very dense source of such radiation would be capable of rotating that quickly without disintegrating.

How are drum brakes adjusted in a Nissan Pulsar?

User Avatar

Asked by Wiki User

on the back of the brake drum (facing the middle of the car) is a rectangular rubber bung. pull that off and inside that should be a small spoked ratchet/gear/wheel. it will only turn one way and you have to use something like a small screw driver. turn it a few clicks and check the tightness of the wheel. continue test and adjust until brakes bind just right. dont do it up too much cos that will cause undue wear on the pads and loosening it off again is a way more time consuming job.

How do you perform a stoppie in your pulsar 150?

User Avatar

Asked by Wiki User

Dude, follow the following steps and you'll get a nice stoppie:-

1. Warm up your front discs by simply applying the brake slightly and running your bike.

2. After this, run the bike at a speed of as low as15km/h, in case you apply the disc harshly you may not topple over.

3. Instead of jamming the brakes completely as many people may say, gradually nand slowly increase the braking pressure before jamming brakes completely.

4. As the above step is done, hold your grip tight both on the handle bar and on the fuel tank, and push your bike forward without getting of your seat.

5. If everything goes well, you'll slightly pop yourself a stoppie, not high enough but under safe limits.

6. Please repeat the above stated steps as frequently as you can so that you easily get used upto to them.

7. Once you are used up to them, increase your speed uptill 30km/h. This will make your stoppies higher.

8. When you get familiar with the stopping factors, you can try rollin stoppies by simply increasing your speed and decreasing pressure on the brake lever.

That's all dude, know you are a stoppie king.

Note:

1. Police hates stunting on bikes, so better check you are alone.

2. Check the gripp of the front tyre and that of the road because uneven grip can lead to accidents.

3. Always wear you safety gear cause you won't know when you'll topple over.

4. In case you topple and break yourself and your bike, please for god sake, don't blame me cause I have flipped thrice of my pulsar and dude it really hurts.

Goodluck..............

How do you remove the dash on a 2003 N16 to change CD player?

User Avatar

Asked by Wiki User

Open top storage compartment,pull towards you removing it, Screws now visable also remove trim by pulling either side of, (above ashtray)

How do you remove the front door trims off a 99 pulsar it is gettin stuck on the window winder?

User Avatar

Asked by Wiki User

Hey just went through the same thing, you have to pull of a little metal clip which is located at the base of the winder, its pretty hard to get of and then back on again, but make sure you don't lose it because you cant put the winder back on without it.

How many 200cc in ml?

User Avatar

Asked by Wiki User

200ml

Where 1988 Nissan Pulsar fuel filter?

User Avatar

Asked by Wiki User

i have no clue

Where can i find aWiring guide to install new HU in 88' pulsar and can i use factory speakers for now?

User Avatar

Asked by Wiki User

Yes, you can use your factory speakers.

1988 Nissan Pulsar Car Stereo Wiring Diagram Car Radio Battery Constant 12v+ Wire: Red/Black

Car Radio Accessory Switched 12v+ Wire: Blue

Car Radio Ground Wire: Chassis

Car Radio Illumination Wire: Red/Yellow

Car Audio Front Speakers Size: 6 1/2″

Car Audio Front Speakers Location: Doors

Left Front Speaker Positive Wire (+): Blue/White

Left Front Speaker Negative Wire (-): Blue/Yellow

Right Front Speaker Positive Wire (+): Brown

Right Front Speaker Negative Wire (-): Brown/White

Car Audio Rear Speakers Size: 5 1/4″

Car Audio Rear Speakers Location: Side Shelves

Left Rear Speaker Positive Wire (+): Red

Left Rear Speaker Negative Wire (-): Green

Right Rear Speaker Positive Wire (+): Blue

Right Rear Speaker Negative Wire (-): Pink

How do you read the fault codes on a n16 pulsar?

User Avatar

Asked by Wiki User

1996 nissan pulsar fault codes

What are 180cc?

User Avatar

Asked by Wiki User

Will a Nissan Pulsar steering wheel fit on a Nissan sunny 1.4 ls hatback steering coloum?

User Avatar

Asked by Wiki User

if the year of the car is the same, then it should fit.

before 92 and aftr 92 were two different fittings so have a check. i have a pulsar gtir steering on my 1.4 and it wrks and fits fine. so if your car is post 92, then the steering should come from a post 92 car also. other cars that also fit include the primera, 100nx, terrano and 100nx. although the primera sits a bit close to the column stalks.

Why do pulsars beep?

User Avatar

Asked by Wiki User

Pulsars rotate like most stars. Pulsars also emit beams of energy which, if they cross our path are perceived as pulses of energy with a regular rate (ticks, beeps, etc). This is called the lighthouse effect. Picture a lighthouse -- the lighthouse itself is the pulsar, and the beam of light is like the pulsar's beam.

Remove cigarette lighter?

User Avatar

Asked by Wiki User

most lighters are a 2 piece assy pull power wire cap off back grab back of lighter a unscre it counterclockwise i hold my thumb in front part where lighter pops out hold with thumb while unscrewing the bace there held together by threads esy fix g