haahahahh
bye bhdhduccuhcuh
haahahahh
Improper calibration of the measuring instrument. If the measuring instrument is not at zero prior to measuring the object you will get a systematic error which, is a value either always higher or always lower then the actual value of the object.
that means having no error.we will know that byerror so we need it.
Zero error is defined as the condition where a measuring instrument registers a reading when there should not be any reading. In case of Vernier calipers it occurs when a zero on main scale does not coincide with a zero on Vernier scale. Source: calculatored and written by Shaun Murphy
Take a measurement with nothing in the gauge. That reading is the zero-error.
A zero error is the reading that an instrument gives when it is measuring nothing. It can also appear as a constant error in all measurements. For example, you cannot measure accurately from the end of a ruler because there is a little bit that sticks out beyond the zero point. Kitchen scales usually need to be zero-ed before use. My car's speedometer does not go below 5 mph so even when parked, the instrument says I'm moving!
Zero error is necessary for measuring instruments for measuring accurate results because it helps to check that the instrument which we are using is whether correct or wrong
The zero error helps in correcting the misreading you get from any instrument. It helps in maintaining the sensitivity of the instruments.
The zero error of a measuring instrument is the measure that it shows when it should actually be showing zero.
No, you have not any knowledge about spherometer. In spherometer also, similar to other measuring instruments zero error should be considered every time; in order to achieve accurate value.
It is a defect in a measuring device (Vernier Callipers & Screw Gauge) & zero error is caused by an incorrect position of the zero point.
Improper calibration of the measuring instrument. If the measuring instrument is not at zero prior to measuring the object you will get a systematic error which, is a value either always higher or always lower then the actual value of the object.
The Vernier caliper is an extremely precise measuring instrument Error is almost impossible The error that we must always look out for is the zero error and parralex error.
that means having no error.we will know that byerror so we need it.
Zero error is defined as the condition where a measuring instrument registers a reading when there should not be any reading. In case of Vernier calipers it occurs when a zero on main scale does not coincide with a zero on Vernier scale. Source: calculatored and written by Shaun Murphy
if the zero line of vernier scale is not conciding with main scale the zero error exists.Knowing the zero error necessary correction can be made to find correct measurement..Such a correction is called zero correction
we can find the zero error by closing the jaw of screw guage if the zero of main scale(MS) is concide with the zero of circular scale (CS) there is no zero error and if they are not concide there is a zero error in screw guage .
The zero error of vernier calliper is defined as :-The zero error is equal to the distance between the zero of the main scale and the zero of the vernier scale.