0
Why does the front wheel of your BMX bike move like its loose when its tightened as tight as can be?
Wiki User
∙ 13y ago
I would suspect that there are problems with the hub. Even if it the quick release or nuts are tights, loose bearings will cause the wheel to wobble or feel sloppy.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What problems can cause front wheel fall off car?
Could be,Wheel bearing failure,Lug nuts not tightened properly,Lug nuts over tightened,Incorrect wheel for that vehicle,Ball joint failure,
New wheel bearing installed and lug nuts tight but wheel can be shook with two hands?
Wheel bearing loose.
When you make a tight turn why is there some vibration in the car?
Possibly worn CVC joint, loose wheel bearing or wheel. Have this looked at ASAP.
2000 Ford Ranger Left side front wheel fell off Why?
lug nuts were not tightened/torqued correctly. I had this happen to me with my jeep i hand tightened them and forgot to go back and torque them.
Your 1994 Plymouth voyager shakes in the front end between 40-60 km hour?
Tire out of balance, wheel bearing loose, wheel loose, defective tire, bent wheel, or worn or loose suspension parts.
Why is a front tire is wearing out on outer edge?
It is out of alignment or wheel bearing is loose.
What does it mean to be 'loose' in NASCAR?
>In Nascar "loose" means that the driver has to control the wheel more than when >it is tight. When it is tight the driver barely has to turn the wheel to get it to go >around the curve, as when it is loose you have to turn it more. Incorrect. Loose means the car oversteers, i.e., the car turns more than you expect and/or the rear end wants to come around so you have to countersteer. Tight means the car understeers, i.e., the front end doesn't want to turn or it turns less than you would expect with the angle you've turned the wheel so you have to steer more into the turn.
How tight should the castle nut be on the rear drum after replacing the wheel bearing on a vauxhall corsa wheel b?
The nut should be tightened then backed off three times to help the bearing seat. On the final tightening go just past hand tight, then back off 1//4 turn.
How do you tighten front wheel bearing on a PT Cruiser?
They are not adjustable, if loose they must be replaced.
What would cause the Front-Left wheel to work the lug nuts loose while driving a 1996 Ram 1500 4X4 360?
If it's alloy wheels you might be missing the steel washer or you might be using the wrong lug nuts. If it's a steel wheel and it was properly tightened, it would seem that someone is messing with your vehicle.
Can Axle nut be too tight on Ford Escort?
Ideally, you want the spindle nut to hold the bearing pack together. Too tight and your bearings wear faster. WAY too tight and the bearings crush. Too loose and the bearings chatter. WAY too loose and the wheel wobbles.
Why is your tire still loose after lug nuts were tightened?
their could be a few reason's, most common is the tyrod or tyrod ends are no good. or in a worse case the wheel barring is no good
