Best Answer

Depending on the sound the cause can vary. A creaking sound usually represents a loose crank ARM or bottom bracket. A clicking or rubbing is usually an out of alignment front derailluer and the sound is the chain passing over the cage.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why MTB made noisy sound when turn the crank?
Write your answer...
Still have questions?
magnify glass
Related questions

What is wrong when i crank my car but it wont turn over and it makes a screeching sound?

check for cats

Can you watch sound?

You can not watch sound. however, you can both feel and watch the effect of sound. Place a cup of water, coffe or milk close to your subwoofer, then watch as you turn on some loud noisy heavy music :-)

Why do 2 stroke engines sound different than 4 stroke?

Because 2-strokes fire on every turn of the crankshaft while 4-strokes fire on ever 2nd turn of the crank.

Who made the rap song turn your crank?

i checked all over the web but cant find da anser srry!

How do you check the bearing on alternator?

If it is noisy, loose, or hard to turn, it is bad.

How do you know if the starter is not working in a Sunfire?

If the starter isn't working, the car will not crank at all. When you turn the key you will either get a clicking sound (which could also mean a dead battery), or you will hear the sound of an electric motor spinning and nothing else.

How can you turn the crank on Big Nate Island?

On Big Nate Island, you use a lobster (no kidding) to turn the lighthouse crank. (see the related question below)

Had the oil changed and the battery replaced today a couple of hours later the rpm went really high and then down to 0 and wont crank will turn over but not crank?

We do not understand "crank" and "turn over" are the same thing.

What is wrong when there is no clicking sound and absolutely no crank when you turn the ignition key to start the car - tried to jump the battery.... still nothing?

try checking your fuses and fuse-able links

What might cause 1992 Ford Tempo crank shaft pulley not to turn when engine is on but accessories turn by hand when engine is off?

If you mean ... why the crank won't turn when the key is on and the acc.'s will turn, Well sounds like crank shaft is locked up. When the crank bearings try to pile up on each other and jam the crankshaft in it's final resting place, till rebuild.

Why would a 85 Grand Marquis crank but not turn over?

Cranks and turn over are the same thing. It may crank or turn over and not start. If that is the case, find out if it needs fire or fuel and go from there.

Can you turn a crank on a motor without removing it?

NO, my god no