0
the differecne is that overload means to much overuse means that you use it to much.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is the difference between overload and progressive overload?
If you are taliking about in a training programme, say you have a six week training programme... overload: making each training session subsequently harder by increasing intensity or duration progression: making the programme harder from the beginning to the end
Difference between overload relay and over current relay?
due to the extension of loads they are using the relays for protection.........
What is the difference between acute and overuse injuries?
acute injury = immediate effect, often easy to accurately relate cause of effect. overuse injury = due to increase frequency, difficult to accurately relate cause of effect
What is the difference between information poverty and information overload?
Information poverty is a lack of information, so having too little information, whereas information overload is the opposite, thus having too much information.
What is the difference between over current and overload condition?
The term, 'overcurrent', describes either an 'overload current' or a 'short-circuit current'.An 'overload current' is a current that is higher than a circuit's 'rated current'. For example, if you have too many loads plugged into the same circuit, then the resulting current is an 'overload current'.A 'short-circuit current' is a large current resulting when a line ('hot') conductor accidentally makes contact with either a neutral conductor or an earth (ground) conductor.
What is the difference between overload and overcurrent?
Overcurrent protection is protection against excessive currents or current beyond the acceptable current rating of equipment. It generally operates instantly. Short circuit is a type of overcurrent. Overload protection is a protection against a running overcurrent that would cause overheating of the protected equipment. Hence, an overload is also type of overcurrent. Overload protection typically operates on an inverse time curve where the tripping time becomes less as the current increases.
What is the difference between overload trip and over current trip. if there is an overload trip the current will be raised above the set point?
An overload trip is due to too much load on a circuit (for example, my wife running a hair dryer and portable heater on the same outlet). An over current trip is the same thing, but it can also refer to an actual fault condition where conductors have come in contact with eachother/shorted.
When was Overload - Overload album - created?
Overload - Overload album - was created in 2006.
How do you overuse forests?
you overuse forests by cutting them down and not replanting trees. You do not overuse if the rate of use=to the rate of replenishment.
What is the difference between a fuse and a time delay fuse?
A time delay fuse will not blow at the first sign of an overload. It will delay blowing just long enough to allow a motor to start or a compressor to startup.
What is the result of muscle overuse?
Muscle overuse results in soreness and stiffnessof the muscles.
