35 ~ 46 Foot pounds of torque. Pressure plate bolts.
The 2001 Nissan valve cover bolt torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.
24 Foot Lbs on clutch cover bolts. 85 Foot Lbs on flywheel bolts. Use lock tight on both set of bolts.
The 2000 Mazda 1.8 liter engine valve cover torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.
The 2001 Mitsubishi Montero Sport 3.0 liter engine valve cover torque specification is 40 pounds. You do not want to over torque the valve cover bolts, as you may ruin the valve cover gasket.
I was told 7lbs
95 in-lbs.
89inch pounds is the torque rating for the valve cover bolts
6-8 lb/ft.
The bolts have a number on it, what is the number? There is a general torque spec in the shop manual that will say what the torque is based on that number
Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .
Usually the clutch bolts do not come out , if you are hearing a grinding noise coming from the cover the cover is warped and needs to be replaced .
Tighten the valve cover retaining bolts in sequence, torque them to 71-106 inch lbs. (8-12 Nm).