0
It depends on a number of factors. The main thing which determines the length your shaft should is the distance between your wrist and the floor, and your middle finger to the floor. The best thing to do is to go get custom fit and see, being 6' 2'' you may need and extra half inch or inch.
What else can I help you with?
Can you snap a golf club and re grip it?
the club will not be up to its normal height (obviously) but the club should be OK as long as the shaft hasn't split when it snapped
How long should a golf driver shaft be if you are 5'9?
You are actually average height. You would be able to use a standard shaft, however if you feel uncomfortable you could get custom fit.
How do you calculate Volume of circular shaft?
(Pi x R x R) x H... Where R is the radius of the shaft and H is the height.
What is the rule of thumb for sizing a key to a shaft?
A common rule of thumb for sizing a key to a shaft is that the key width should be approximately 1/4 of the shaft diameter, while the key height should be about 1/2 of the key width. For example, if the shaft diameter is 1 inch, the key width would be around 0.25 inches, making the key height approximately 0.125 inches. This sizing ensures sufficient strength and grip without compromising the integrity of the shaft or the keyway. Adjustments may be necessary based on specific application requirements and loading conditions.
How long should a shaft be for an adult using a ram 4 v force golf club?
Correct shaft length depends on the height of the individual. It must be at least 18 inches and up to 48 inches in length, though a putter can be longer.
I am installing a 4.5 inch lift on a Cherokee will i need extras driveshafts and etc or can i just toss it in and go?
If you are changing the height of the vehicle and not the length you may be able to keep the same drive shaft. However if you change the height by too much, you may have to get a longer drive shaft. Try it with the shaft you have after the kit is installed and then you will know if you need to change your shaft.
Runout on a shaft should not exceed?
.002 per foot of shaft
How deep is a normal mine shaft?
80 to 100 foot deep
Should the short shaft turn on your 94 wrangler when in 2wd?
If you mean the front drive shaft, yes it should.
Why shaft generator can not operate in parallel with auxiliary generator?
Normal shaft generators do not have droop-control for frequency and voltage. Semiconductor (drive) based variable speed shaft generators may have those today.
How long is a chukka?
A chukka boot typically has a shaft height that falls above the ankle but below the calf, measuring approximately 3 to 4 inches in height.
How small does a lacrosse shaft have to be?
a lax shaft for children under 5ft. should range about 3 - 4.5 ft. if u are over 5ft the top of your shaft should be up and right over your hips
