0
nothinng
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why does your car shake when coming to?
A stop- Rotor out of round, possibly bad wheel bearing.
Car shudders when breaking?
Probably have a warped or out of round brake rotor or brake drum.
What causes the caliper piston to move away from the brake rotor when the pedal is released?
Rotor "Out of Round" when rotating "High" spot will cause piston to retract into caliper body
What causes the caliper piston to move away from the rotor when the brake pedal is released?
Rotor "Out of Round" when rotating "High" spot will cause piston to retract into caliper body
Why does your car steering shake and veer to the right?
Could be a frozen brake caliper or a rotor that is "out of round".
Does a 92 Nissan maxima have a cap and rotor if so where are they located?
open the hood look on top to the left. The round object that looks like a octopus with 7 tentacles attached to it is the cap and rotor.
What are the signs and symptoms of burnt valve in 1993 Lexus sc300?
if you have a burnt valve the cars tailpipe will make a pop,pop,pop,pop,noise,and if you place your hand on the tailpipe it will try to suck your hand in.CHECK your plug wires,caps and rotor buttons first.
How does a wind turbin produce energy?
The rotor is driven round by the wind and this drives a generator which is mounted behind the rotor and connected by a shaft. The electrical energy is then transmitted down the support column and distributed to the outside world.
What causes 2000 silverado to shake when braking?
Brake rotor/rotors are out of round / warped. Check rotors and REPLACE as needed.
What is a disk or a round thing that turns around a fixed central point in a car?
Could be a disc brake rotor, pulley.
How do you take a rotor off a 1999 Daewoo is it the center nut or the screw on the rotor?
The center nut is for the hub assembly. You need to remove the screws on the rotor. The screws might be stuck to the rotor when you try to take it out. If this is the case, be careful when you use the screwdriver. You might round out the screw head. When the screw is hard to remove, I usually use a 1/4" socket wrench, 1/4" socket, and screwdriver bit. The screwdriver bit will fit inside the 1/4" socket. This gives you extra torque and won't round out the screw as a screwdriver might do. Once the screws are out, the rotor should come right off.
Why Vibration on brake pedals while stopping?
More than likely a front or rear brake rotor is out of round. Depending on what model and year vehicle it could be a brake drum out of round also.
