It would depend on if finger inserts are used in the ball. If inserts are used, simply replace the inserts with a larger value. If inserts are not used, use a bevel, scraper or sand paper to open up the hole.
There Are 3 holes in a ten-pin bowling ball.
3
There is usually 3 holes in a Ten Pin Bowling Ball. 1 large hole for your thumb and 2 smaller holes for your middle and ring finger. Some bowlers may have different numbers of holes based on their bowling style.
It depends on the person's grip, style of bowling, hand strength and intention. They are termed as finger/thumb pitch.
Because you sweat you idiot!
u can have up to five (one for each finger) but most balls have 3-4 holes. one for thumb, one for middle finger, one for ring finger, and for higher preformance bowling balls, they usually have a counterweight hole so that it balances the ball ass it rolls down the lane.
A low track usually refers to the oil track on your bowling ball. The closer the track is to your finger holes, the HIGHER the track. The farther away the track is to your finger holes the LOWER the track.
Usually about 2-3 ounces.
Zero, the ball is smaller than normal bowling balls and it fits into your hand so you don't need finger holes in order to roll it.
The vast majority of bowlers use a ball that has three holes drilled in it and some bowlers use four holes the extra one for the pinky finger.The three holes are for the thumb,middle finger,and ring finger.
obviously a bowling ball without holes, how could something with less material in it weigh more
They don't HAVE to have three holes - people used to drill two holes and palm the ball, but it's easier to control the ball with three holes.