How do you varial kickflip on a skateboard?

Answer 1

Foot position to varial kickflip just put your back foot like a pop shuvit and your front foot like a regular kickflip, only pointing a little more to the nose than a regular kickflip. the flip you want to POP the board, not shuv, and when the board is touching the ground for the pop, or slightly in the air, you want to roll your ankle and kick straight forward. if you dont roll your ankle to make it flip, then you will end up with a lame pop shuv. after that lift your legs up. oh, and you have to jump forward, otherwise you will land with one foot or with your toes. hope it helps

Answer 2

1.) Get speed2.) Start your footing for a kickflip, except you put your left foot for a 360.3.) Start a kickflip then at when the board (horizontally) is 315 degrees start up a 3604.) Land the board

Answer 3

first you put yer front foot in the middle of the board and lower yer front foot till its half way down and set yer back foot curved into the back of yer board then u pop yer back foot up and flick yer front in a kinda diagnil flick and catch it with yer front foot yer back foot tends to land off the back of yer board so while u flick shove yer back foot up at least 2 inches and that's how u do a kickflip good luck!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! submitted by miles kerbs

if you land on at least two bolts on each side it will be a clean kickflip

Answer 4

first get a good board with good grip tape. next make sure you know how to ollie first. after that go for an ollie but flick the ball of your foot of the side of the board closest to you and jump. wait for the board to flip until the grip tape comes back around and push your feet on and land. Good luck!!!!

Answer 5

Pop the board as if you are going for a shuv then flick your foot out as you would for a kickflip. Do these at the same time. Jump as you would for a shuv. Land it. Bolts!. Roll away.

Answer 6

Make sure you don't scoop your front foot.

Answer 7

first you kick then you flip