answersLogoWhite

0


Best Answer

the rear tire tube on a 70cc baja dirt bike is 3.0-12

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How big is the rear tire tube on a baja 70cc dirt bike?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is there a way to install a shock on the rear of baja mini bike?

It's not easy to do.


Can you put TTR125L dirt bike tires on a regular TTR125 dirt bike?

No, the L denotes larger wheel, the TTR125L uses a 19" front and 16" rear while the TTR125 uses a 17" front and a 14" rear.


How much psi does a1997 rm 250 dirt bike rear shock hold?

160 psi of nitrogen in the rear shock.


How do you remove rear wheel bearings on a Honda cr125 dirt bike?

Look for a different website. This one rarely has answers.


How do you make a dirt bike fast?

replace reed valves. get fmf pipe. bigger rear sprocket for top end speed. start it take off hang on.


Can you swap tires from a 2006 YZ250F to a 2009 YZ250F?

yes, the dirt bike doesnt have to do with it. It depends on the tire size, and yes they both have the same size tires in frount and rear.


How much air preesure goes into a Honda dirt bike xr100 front tire?

For XR100R: 14 PSI front, 18PSI rear, For XR100: 18PSI front, 20 PSI rear, For XR 100S:21 PSI for BOTH. Lower air pressure a pound or two for a light rider, loose dirt or sand.


Setting the carburetor to factory settings on the baja heat mini bike?

The black Phillips head screw on the rear of the carburetor adjusts the airflow. You need to have it about 4 full turns into the hole and that's factory. To set the carburetor, just continue to screw in the air screw until the bike runs properly. In your climate, you will hear and feel the bike get smoother as the carburetor gets to the proper setting. Try it out and have a blast!!


How do you find out what bike you have?

well on some dirtbikes it has it copied on the side of the front stock wich is the part of the frame just above the front mudgaurd (behind where a headlight would normally be) or you can also check the engine model number(usually locted directly under the carby on the motor) and compare it on the manufactuers website, if not then check the dirt bike manual


How can you make 50cc dirt bike faster?

port out the cylinder head, replace the muffler, get a performance air filter, get a smaller sprocker for the rear wheel,and take off any electronics that you dont need.


Where is the vin number on your dirt bike engine?

The VIN number is not located on the engine, it is as a rule located on the front of the bike frame. The engine has the engine number, which is different from the frame or VIN number. Look for it on the top front of the frame, just below or to the rear of where the handlebars column is placed in the frame.


What is the bike's light called?

Rear Light