I can tell you from the top of my head right now that the all-time RBI leader is Hank Aaron, but here is a source.
the source current is the current that flows from the power source.
For a current to flow there must be a voltage, and a conductor through which the current can pass.
Luc Van Lierde went on to clock the fastest Ironman Triathlon ever in 1997, doing 7:50:27 (0:44, 4:28, 2:36, plus transition) in Ironman Europe. source: http://en.wikipedia.org/wiki/Luc_Van_Lierde
A current source produces a constant current no matter the variation in voltage.
Simple source of direct current are Batteries.
Take the internal series resistance of the voltage source and make it the internal parallel resistance of the current source. Then compute using Ohm's law the current of the current source to be equal to the maximum current the original voltage source could supply a short circuit load. Note: the two sources are equivalent.
The maximum current that can be drawn from a voltage source is dependent on the impedance of that source, the impedance of the connections to the source, and the energy available from that source.
internal resistance is always infinite in ideal current source .the internal resistance is in shunt with current source
resistance does not produce currents . you need source (like voltage source , current source ,or , discharging capacitor) to generate current .
First you will need a constant current source. Do NOT connect the voltmeter to the constant current source without the resistor to be measured already connected. Do NOT use a battery, it is a voltage source. Then follow these steps to measure a resistor:connect the voltmeter across the resistor to be measuredconnect the voltmeter-resistor combination across the constant current sourceread the voltmeter and record the voltagedisconnect the voltmeter-resistor combination from the constant current sourcedisconnect the voltmeter from the resistorcalculate the resistance from the measured voltage and current from the source with Ohm's law in this form: R = V ÷ IIts much easier to just use the ohms setting on a multimeter.
A: An ideal current source can be defined as a short with immense current capabilities A zener has no such capabilities
A current source varies the output voltage to maintain the desired current. A voltage source has a constant output regardless of the current draw (up to the capacity of the supply, of course).