0
Could a bad golf cart charger cause batteries not to stay charged up?
Wiki User
∙ 7y ago
Of course it is possible but more than likely you have 1 or more batteries with a dead cell. This will drain all the other batteries. You need to have all the batteries checked to make sure.
Wiki User
∙ 7y ago
Add your answer:
Earn +20 pts
Can Nimh batteries can be charged with Nicd charger?
It is always better to use a charger designed to charge a particular battery type. Using a NiCad charger for NiMh batteries or vice versa can cause damage to the charger or batteries, especially if the charger is designed to charge the batteries in under two hours. The worst case is a fire risk. Some charger and battery combinations will work perfectly well together but it is safe to assume that the charger will only be suitable for the battery types stated on it.
If you have two batteries in parallel can you use a one bank charger or do you need a two bank with both hooked to the batteries?
You will want to use just one charger because once you add the other charger you will be giving 24v to a 12v system and that could cause fuse issues.
Can you charge a car battery the wrong way round?
No! You should never cross connect two batteries or a battery to charger in this way. At minimum the battery could be damaged. At worst it could cause an explosion.
Can you regarch NiMH batteries in an alkaline battery charger?
I think you will find that this is not at all recommended. Different battery types have different ratings for charging current, voltage when charge is complete, trickle charge current and also temperature they can handle. Using a charger that is not designed specifically for the battery type you have can cause the battery to be charged too fast or too long, which can shorten the life and capacity of the battery - and worse, could cause unsafe pressure buildup.
Using a AAA Battery Charger?
Have you ever wondered how you can benefit from a AAA battery charger? Make sure that the batteries you are trying to charge in it are actually rechargeable. Other batteries can cause a fire risk because they are not designed to be placed into a battery charger. Look at the side of the battery to find out if it can be recharged.
How can you connect 2 12volt batteries to be charged serially with a 24volt electric charger and a12volt solar board so as not move cables around and also charge with both chargers at the same time?
I don't believe this can be done. Someone else may have a better answer but for one charger you need the batteries in series and for the other you need them in parallel. Even if that weren't the case, having 2 voltage supplies connected together will cause problems, possibly a fire. Each charger will supply voltage to the other and they are not made to handle that.
What is the difference between battery charger and intelligent battery charger?
a simple battery charger only charges the battery and having no feedback from the battery status, it can cause overcharging, increase temperature, and can damage the battery or in worst case can blow up the battery, also mitigates the life time of the battery. whether intelligent battery charger charges the battery and get feedback from the battery , when the battery gets fully charged it Cut off the charging circuit itself, also maintain the charging at its trickling current to control the temperature. simply it shows the status of the battery. i hope its the Good answer. thanks although the intelligent battery charger charges the battery and get feedback from the battery,the batteries have different charge characteristics. For example ,some intelligent battery charger detect △V and △T to control charge. However when batteries has been charged fully,they will show different characteristics. some battery has show the voltage dropped,but in fact they has not been charged fully,even charged a little just because the wave input voltage.some batteries has show the voltage dropped,but the batteries has charged fully for a long time.So acccording to the △V not to determine the fully charged.△T has the same problem and when the same battery charged fully will come different temperature,if the charging current is different. So △T is worse than the △V. Finally,although the intelligent battery charger can get feedback,now the battery charge characteristic is unsure.So it is no sense. I think battery charge should be distinction by constants current or constants voltage.they will produce obvious different effect of charge.
Could storing dead batteries in the freezer cause the batteries to work for a short while?
I dont know the answer
Can you charge a 6 volt battery with 6 volt charger?
No. The battery will be charged at a rate which is 2* the normal rate. This will cause the battery to overheat which might cause it to explode.
Does switshing battery cause toyota 2002 to stall?
Are you saying switching? If so, the answer is no. Switching batteries will not cause it to stall as long as you install a fully charged battery.
How do you charge battery with ac power supply I have a 12 volt dc battery and im trying to charge it with a power supply rated at 0-40 volts 0-5 amps?
You should charge the battery with the proper battery charger. The battery charger should list what types of batteries, voltages, and charge rates (amps) it is compatible with. Make sure this matches the information on the battery to be charged. Using the incorrect battery charger can cause battery explosion, leaking, or fire.
Can you use a 12 volt charger to charge 6 volt batteries in recessive situation?
That really depends on how the charger is made. What would likely happen is that the charger would try to deliver more current than it is designed to. The result would be either a blown fuse or diodes in the charger unless it has protection circuits in it. One thing you could try would be a current limit in series with the charger output. A headlamp in series could work to limit the current to somewhere around 3-6 amps and prevent having an overcurrent situation on the charger. Dad calls the light bulb current limit a "rubber fuse" It will take longer to charge that way and you really need to check the battery voltage often making sure not to exceed about 6.75V Be aware that with this method there is no way for the charger to sense that the battery is fully charged. It will continue to try to push to around 14 volts which will never happen until you cause an open cell in the 6v battery. charger + to headlamp bulb, other side of bulb to battery+ B- to charger- That could get you out of a pinch but you really need a charger designed for 6v charging.
