0
Can you put an stx bionic lacrosse head on an stx al 6000 pro shaft?
Wiki User
∙ 16y ago
i wouldn't see why not
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is better warrior mojo or stx bionic?
tough choice but i personally like the mojo better than the bionic, but a good lacrosse player can play with any head or shaft
Could you put an STX Bionic Lacrosse head on a STX crank shaft 7075?
No. The Crankshaft 7075 only works with specific heads, and a Bionic won't fit right.
Could you put an STX Bionic Lacrosse head on a Warrior Platinum shaft?
yes, you can but you might have too put some force into putting it on the shaft because the shaft has differant ridges but it will still fit "legally".
What is a shaft in lacrosse?
The shaft in lacrosse is the stick part. The butt is the rubber stopper on the end of the stick. The head is the plastic part which has the pocket. The shaft is the part of the stick where you hold it.
Can you put a brine lacrosse shaft on a warrior head?
It shouldn't matter. Any head should fit on any shaft
How long is a lacrosse defense shaft?
the shaft itself is 60" long. With a head attached it is 6ft.
Do you need a Crank Shaft Head to put on a Crank Shaft in Lacrosse?
I would recommend that you do put a crank shaft head on a crank shaft. Putting any other type of head on a crank shaft could possibly break the head.
What do you do if if your lacrosse shaft is too big for its head?
Wrap tape around the top of the shaft to however much more thicker you need. The best tape to use is electrical.
Is it bad if your lacrosse head and shaft are the same color?
only if it is blacked out
Will a Gait Lacrosse head fit on an STX lacrosse Shaft?
Any head can be put on any shaft. All you have to do is put the bottom of the head in warm not boiling water, just warm tap water for a few minutes and it should slide rite on to your maverick shaft if it doesn't already.
How do you put lacrosse head on shaft do I use a hammer?
no, just use muscle !
How do you get a very tight lacrosse head onto a shaft?
To get a very tight Lacrosse head onto a shaft, spray both sides with a lubricant. WD-40 is a good lubricant for this procedure. Liquid Wrench will also work.
