0
Can the ignition switch have anything to do with speedometer not working or transmission not upshifting?
Jlvik
yes. the neutral safety switch is connected to all of them.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Can the ignition affect the transmission?
No, it has nothing to do with the transmission.
Why does my mileage still shows on the speedometer of your Mercedes sprinter van when the engine is of?
Try putting the key in the ignition and taking out quickly, and or lubricate the ignition lock mechanism. it worked for me.
Why would the automatic transmission not shift out of 1st and the speedometer stop working on a 1992 Toyota 6-Cyl 4Runner when the ignition timing is retarded?
Try replacing the vehicle speed sensor (VSS). It's held in place on the side of the transmission by a single bolt and it has a single electrical connection. I had the same problem, and this cleared it up instantly!
Does transmission issues cause start up problems?
no the transmission and the ignition system are two unrelated parts
Where is the transmission speed control sensor and what does it look like on a 1992 Chevy Van?
I suppose that it would depend on the transmission used. I have a 1992 G30 (slowly falling apart with 251,000 miles on it) with the 4L-80 E Transmission (heavy duty 4 speed electronically controlled auto). There are two speed sensors, both on the left (driver's)side of the transmission. Both have a two-wire connector. The input speed sensor is located towards the front of the tranny, and the vehicle speed sensor is located towards the back. The input speed sensor measures the transmission's input speed (i.e. the rate that the engine is turning the input to the transmission) while the vehicle speed sensor is used for measuring the vehicles speed (i.e. the rate at which the rear wheels are turning). Its signal is also used for the speedometer - there is no speedometer cable going to the speedometer. Mine is currently busted - transmission won't upshift and speedometer reads 0. Replaced the sensor to no avail. Someone suggested that I check the ignition switch, as part of it might be broken. In general we have had a lot of problems with the electronics on this van, including wiring and connectors failing. Good luck with yours. Richard Rea
Can the ignition switch in a 1990 Chevy pick up cause the transmission to not shift?
NO, there is no coalition between the ignition switch and the transmission. The ignition switch does 2 things. Turns on power to the electrical system for the engine and supplies power to the starter during start-up.
What does VTI stands for?
it means variable vavle timing or transmission ignition.
What transmission is in a 1997 Blazer?
The 1997 Blazer came with a 4L60E 4 speed automatic transmission. This transmission is electronically controlled, which is particularly good to know when dealing with the 1997 year model. The 1997 Blazers are known to develop faulty connections in the electrical ignition switch that can interrupt the power to the transmission. When this occurs, it makes it seem as though the transmission has gone bad, when in fact the ignition switch is the real culprit.
What are the symptoms of a bad speed sensor?
Some symptoms of a bad speed sensor are a speedometer that does not work or stops, a vehicle losing power unexpectedly, rumbling or idling of the vehicle, and transmission problems when trying to shift gears. The sensor has many functions in a vehicle, including ignition timing, fuel regulation, and the operation of cruise control.
Why would the speedometer on a 92 s10 quit working?
ignition switch under dash will cause preimpted failure if kicked out sequence with key starting rod.
What is the ignition timing degree for a 1985 Chevrolet S10 2.8L V6?
Automatic transmission - 10 degress BTDC Manual transmission - 6 degrees BTDC
How do you know if your 2001 ford ranger is in theft mode?
its always in theft mode. There should be a little light that will flash on the dash or around the speedometer when the ignition is off and the key is out.
