answersLogoWhite

0


Best Answer

No, the front wheels of a skateboard should be as tight as the back ones. The reason for this is when your turning the front side of the board may table-clip your wheels causing you to stop short, and the front side may cause you to wobble and lose control,(usually happens when you're racing someone or riding really fast.)

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Are the front wheels of a skateboard supposed to be loose for turns?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does the wheels of the skateboard rubs against the skateboard?

its called wheel-bite, it means your trucks are loose. And to avoid falling, i suggest tightening them a bit.


Are skater shoes supposed to be loose?

well i pesronally perfer em lose but its harder to skateboard dude


Are turbo skateboard are real?

Well, if for turbo skateboard you mean a skateboard that goes really fast, then the answer is yes! It all depends of the type of wheels you are using, the trucks and how loose or tight they are, the material of the skateboard, the strenght you put on your toes when impulsing and the ground where are you skating.


Are loose skateboard tucks good?

no they are not


What is over stear?

Oversteer is when a car turns into a corner and the back of the car breaks loose, not following the same line as the front wheels.


What is the advantage of rolling wheels over sliding wheels in an emergency?

Rolling wheels have more traction than sliding wheels. Thus you have more control. To illustrate; If you were in a turn and either locked the brakes or accelerated too fast the rear wheels loose traction and the rear of the car starts to pass the front of the car.


Are trucks on a Tech Deck supposed to be loose?

NO! they're not supposed to be loose if they are use the yellow thing to tighten it.


Why do your wheel shake and pull to the right when you are driving?

Check the front end components. Most likely there is a loose or worn part causing the shaking of the wheels.


Why do the front wheels on your dodge ram 3500 maxi van tilt in at the top?

If you are talking about the front wheel you have either a loose suspension component or weak springs. If you are laking about the rear wheel, you have a bent axle.


Are you supposed to loose your wisdom teeth?

No


2003 dodge caravan front wheels sound loose?

step one is the check lug nuts ----------- step 2 is the axle busted grease around axle


Are you supposed to lose your moler s?

ur spose to loose ur front ones not the back ones